Draft Commander 3000® A/T Mobile Fire Pump - Weis Fire & Safety ...
Draft Commander 3000® A/T Mobile Fire Pump - Weis Fire & Safety ...
Draft Commander 3000® A/T Mobile Fire Pump - Weis Fire & Safety ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Draft</strong> <strong>Commander</strong> <strong>3000®</strong> A/T<br />
<strong>Mobile</strong> <strong>Fire</strong> <strong>Pump</strong> Testing & Training Simulator Specifications<br />
MODEL NUMBER DC1911-3000 A/T<br />
Purpose Specific Engineered Aluminum Heavy Duty DOT Rated Transporter:<br />
‣ The Aluminum <strong>Draft</strong> <strong>Commander</strong> <strong>3000®</strong> A/T transporter is specially designed and<br />
manufactured only for the <strong>Draft</strong> <strong>Commander</strong> <strong>3000®</strong> A/T to maintain a low profile for<br />
minimal wind resistance, weight distribution, and safety.<br />
‣ The front of the <strong>Draft</strong> <strong>Commander</strong> <strong>3000®</strong> A/T transporter is equipped with an<br />
aluminum tread plate shield 46 ¾” high by 78” wide to protect and reduce wind drag<br />
when transporting.<br />
‣ There is to be a minimum of 18” between the front shield and the front of the <strong>Draft</strong><br />
<strong>Commander</strong> <strong>3000®</strong> reservoir. This space is for extra storage for equipment and to gain<br />
access to the front ventilator.<br />
‣ Two (2) 6,000 lbs. Torflex 22 ½” up axles with 12,000 GVWR equipped with electric<br />
brakes.<br />
‣ Aluminum transporter designed and engineered for distribution of weight of the <strong>Draft</strong><br />
<strong>Commander</strong> <strong>3000®</strong> A/T and its components.<br />
‣ Two (2) sets of mud flaps to be installed on transporter.<br />
‣ Equipped with four (4) 7000 lb. capacity screw type jacks to support transporter when<br />
the reservoir is filled with water. Jacks are located: two (2) on left side and two (2) on<br />
right side.<br />
‣ One (1) 10,000 lb. tongue jack.<br />
‣ Equipped with load transporter tires, ICC Lights, work lights, stop, and turn signal<br />
lights.<br />
‣ Equipped with a crossbar at rear 15” high above the <strong>Draft</strong> <strong>Commander</strong> <strong>3000®</strong> A/T with<br />
stop, tail, and turn signal lights.<br />
‣ 3M reflective tape on front, rear, and sides of unit.<br />
‣ Floor of transporter to be extruded aluminum.<br />
Note: Wood or steel flooring is not acceptable<br />
‣ Folding rear step and work area of transporter is 16” deep X 77” wide.<br />
‣ Fenders of transporter to be aluminum tread plate and equipped with two hold brackets<br />
for mounting the entrance steps for entering the pitot nozzle changing compartment.<br />
‣ OAW (less water) not to exceed 6,500 lbs.<br />
‣ Over all height not to exceed 70 inches (low profile).<br />
‣ Over all length not to exceed 27 feet.<br />
‣ Standard RV 7 pin electrical connector.<br />
Revised 7-2012<br />
Page 9