Cold Weather Smart Card - Fort Wainwright - U.S. Army

More documents

Recommendations

Info

Ten-Man Arctic Tent 16. Tent Line: Door Eave 17. Snow Cloth 18. Tent Slip 1. Ventilator 2. Telescopic Tent Pole 3. Stovepipe Opening 4. Tent line: Eave 5. Tent Stake 6. Tent line: Corner 11. Chape Snap 12. D-Ring 13. Toggle Loop 14. Tie Tape 15. Tent Lug NSN: 8340-00-262-2877 TM: 10-8340-222-10 7. Tent line: Corner Eave 8. Foot-stop 9. Becket 10.Toggle Erect a Ten-Man Arctic Tent (1) Remove snow to ground level to the diameter of the tent plus area to extend snow cloth. (2) Extend the tent out and position stovepipe opening down wind. (3) Zip both door entrances (to include liner) shut. (4) Fully extend all corner eave lines (7). Mark spots on the ground approximately six feet, (two steps), from each corner of the tent. Drive tent stakes on the marks. (5) Extend the center pole to a length between 6 and 8 feet and lock it in this position. Place the stud at the top of the center pole through the hole in the perforated metal plate at the roof apex. Erect the tent by holding the pole vertically and placing the pole board underneath the base of the telescopic tent pole. (6) Attach and tighten the corner eave lines, then the corner lines (6) to the same stake. (7) Attach and tighten the four eave lines (4) to a stake. (8) Place door poles three feet from tent. Clove hitch door eave (16) line at five feet in height. Attach line to a stake six feet from tent. (9) Spread the snow cloth (17) on the ground outside the tent (DO NOT ANCHOR!) and open the four ventilators from the inside by pushing them outward.
NSN 4520-01-444-2375 TM 10-4520-261-12P Lighting the stove (1) Tip fuel can and let stove prime for 2 to 5 minutes. (2) Hold the priming cup under priming valve on fuel supply hose. Open the valve slowly and fill the cup with fuel. (3) Pour fuel into the bottom of burner. If the outside temperature is below -25º F, pour one additional cup. (4) Take one square of tissue or paper and soak up any excess fuel that may remain in the cup. (5) Light the fuel soaked tissue and toss it into the bottom of the burner. Use the cleaning tool, if necessary, to make sure that the burning tissue reaches the bottom of the burner where it can ignite the priming fuel. Close the Lid Assembly. (6) When the heater has warmed up sufficiently and begins to give off heat, gradually adjust the flow adjustment knob to desired heat output. *Operators require license to operate SHA
Page 1 and 2: U.S. Army Northern Warfare Training
Page 3 and 4: Risk Of Frostbite WIND SPEED(Use Be
Page 5 and 6: Superficial Frostbite Freezing of t
Page 7 and 8: Immersion Syndrome Non-freezing col
Page 9: 22 24 Ahkio Packing List 2 21 9 23
Page 13 and 14: Snowshoe, Assault, Military with 8
Page 15 and 16: Generation III ECWCS Level 1: Base
Page 17 and 18: Generation III ECWCS Level 5: Outer
Page 19 and 20: Gloves Glove Inserts • Not a stan

Cold Weather Smart Card - Fort Wainwright - U.S. Army

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?