PLC Programming

6 - The Resources
ppt
pid
pinf
tsk
startprg
stopprg
resetprg
resetprgcold
resetprgorg
reload
getprgprop
getprgstat
Read POU table
Read project Id
Read project info
Show IEC-task list containing task infos.
Start PLC program
Stop PLC program
Reset PLC program
Reset PLC program cold
Reset PLC program original
Reload boot project
Program properties
Program status
filedir
filecopy
filerename
filedelete
saveretain
restoreretain
setpwd
delpwd
File command "dir"
Copy file [from] [to]
Rename files [old] [new]
Delete file [filename]
Save retain variables
Load retain variables
Set password on controller
Syntax: setpwd [level]
can be "0" (default) just valid concerning logins from the programming
system, or "1" valid for all applications
Delete password on controller
Note: The first word of the command sequence entered is interpreted as keyword. If a keyword is preceeded by a
„" (e.g. „mem "), the ini-file will be searched for the existence of a help section to this
keyword. If one is available, nothing is sent to the controller, but only the help text is displayed in the
output data window.
If the first word of the command entry () is not recognized by the controller, the
response 'Keyword not found' will appear in the result window.
6.12.3 Use of macros during the command entry in PLC-Browser
If a command associated with a macro is entered in the command line, this is expanded before it is
sent to the controller. Then the response in the result window appears in a similarly expanded form.
The entry syntax is:
is the command.
Macros are:
%P
If NAME is a POU-name, the expression is expanded to , otherwise
there is no alteration
CoDeSys V2.3 6-59