Stopwatch and Timer Calibrations - National Institute of Standards ...

Appendix B
Appendix B
References
[1] B. N. Taylor and A. Thompson, (Eds.), “The International System of Units (SI),”
Natl. Inst. Stand. Technol. Special Publication 330, 2008 Edition, March 2008.
[2] BIPM/IEC/IFCC/ISO/IUPAC/IUPAP/OIML, Guide to the Expression of
Uncertainty in Measurement (GUM), 1995.
[3] International Organization for Standardization (ISO), International Vocabulary of
Metrology – Basic and General Concepts and Associated Terms (VIM), 2008.
[4] International Organization for Standardization (ISO), General Requirements for
the Competence of Testing and Calibration Laboratories, 2005.
[5] R. J. Anderson and G. L. Harris, “Specifications and Tolerances for Field Standard
Stopwatches,” Natl. Inst. Stand. Technol. Handbook 105-5, October 1997.
[6] Robbins, Michael, “Electronic Clocks and Watches,” Howard W. Sams Co.,
Indianapolis, IN, 1975.
[7] J. R. Vig, “Introduction to Quartz Frequency Standards,” Army Research and
Development Technical Report, SLCET-TR-92-1, October 1992
[8] North American Electric Reliability Council (NERC), “Time Error Correction,”
Standard BAL-004-0, April 2005.
[9] T. Butcher, L. Crown, L. Sebring, R. Suiter, J. Williams, editors, “Specifications,
Tolerances, and other Technical Requirements for Weighing and Measuring Devices,”
Natl. Inst. Stand. Technol. Handbook 44, 2007 edition (updated annually).
[10] M. A. Lombardi, “Legal and Technical Measurement Requirements for Time and
Frequency,” Measure: The Journal of Measurement Science, 1(3): 60-69, September
2006.
[11] State of Pennsylvania code, 67 § 105.71(2), 2005.
[12] R. M. Graham, “Calibration Techniques for Stopwatches and Timers,” Proc. 2003
National Conference of Standards Laboratories (NCSLI), 6 p., August 2003.
67