Ready to measure force? - Brosa AG

More documents

Recommendations

Info

Force measuring pin, type 0201 For the precise force measurement at bearing points BROSA force measuring pins are made of highstrength stainless steel and meet the highest requirements. Depending on the applicationspecifi c conditions the BROSA force measuring pins are designed and produced according to different, partly patented design concepts. High measurement accuracies are ensured for a long time by considering the exact installation situation from the construction to the calibration of the sensors.
Tubular load cell, type 0206 For the fl exible measurement of radial forces BROSA tubular load cells measure radial forces acting on an axis with a constant or variable direction of the force transfer. BROSA tubular load cells can be used even in case of axes that had not been suitable for force measurements due to their dimensions or defl ection. The combination of several tubular load cells on one axis is possible. Optionally, it is possible to equip BROSA tubular load cells with an integrated angle sensor that measures the inclination of the sensor. The output signal can be the resulting force or even the rope load in case of sheaves.
Page 1: Ready to measure force
Page 4 and 5: David and Goliath For our customers
Page 8 and 9: Tension load cell, type 0111 For th
Page 10 and 11: Force sensor washer, type 0120 For
Page 12 and 13: Support jack load cell, type 0106 F
Page 14 and 15: Measuring block, type 0230 For meas
Page 16 and 17: Pressure transducer, type 0301 For
Page 18 and 19: Angle sensor, type 0802 For precise
Page 20 and 21: ATEX Sensors For the use in explosi
Page 22: A brief look back Or why today’s

Ready to measure force? - Brosa AG

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?