i-MOTION 3 Ins.indb - Sram

More documents

Recommendations

Info

ASSEMBLY OF COMPONENTS GEAR ADJUSTMENT » Shift the gears up and down repeatedly before setting the shifter so that the shift cable can settle. 31 31 Shift the twist shifter to the 3rd gear. The shift cable must be without play in 3rd gear. That means it must be pulled out of the hub as far as it will go. 32 While pulling the plastic retainer (1), it should not be possible to pull the shift cable further out of the hub. – Shift cable has too much play: Shift the twist shifter to the 1st gear. Reduce play of the shift 33 cable by turning the barrel adjuster (2) at the shifter. – Shift cable is too taut: The shifter won‘t shift into 3rd gear or the hub doesn‘t shift in 1st gear or will permanently switch between 1st and 2nd gear. Shift the twist shifter to the 1st gear. Decrease shift cable tension by turning the barrel 33 adjuster (2) at the shifter. 16 32 33 2 » Shift the twist shifter to the 3rd gear and check again, until there isn‘t any play in the shift cable. i-<strong>MOTION</strong> 3 · June 2006 1
ASSEMBLY OF COMPONENTS E i-<strong>MOTION</strong> 3 · June 2006 17
Page 1 and 2: E user manual D betriebsanleitung F
Page 3 and 4: TABLE OF CONTENTS E THE SRAM i-MOTI
Page 5 and 6: OPERATION SHIFTING Shift gears by t
Page 7 and 8: MAINTENANCE AND CARE REMOVE AND FIT
Page 9 and 10: MAINTENANCE AND CARE REMOVE AND FIT
Page 11 and 12: MAINTENANCE AND CARE REPAIR WORK /
Page 13 and 14: ASSEMBLY OF COMPONENTS 20 Slide one
Page 15: ASSEMBLY OF COMPONENTS ASSEMBLY SHI
Page 19 and 20: TECHNICAL DATA E HR 78 100 124.5 Ø

i-MOTION 3 Ins.indb - Sram

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?