SPCA 001-010RSB

ñ Hydraulic circuit pump control.
ñ Compressor start up time delay function.
ñ Compressor running time records.
ñ Over 150 programmable parameters.
ñ Fan motors overload protection.
ñ Auto diagnostic stop function due to low water circulation,
high / low operating pressures and compressor thermal
overload.
ñ Auto diagnostic function and digital display of approximately
30 possible error codes including thermistor faults.
ñ Digital displays of inlet/ outlet as well as condensing
temperatures.
ñ Remote on / off selection.
ñ Various other optional control capabilities (listed in options).
REFRIGERANT CIRCUIT
The unit shall have a single refrigerant circuit with one
compressor. The circuit shall consist of a filter dryer, expansion
device, solenoid valve, high and low pressure switch with manual
reset.
NOTE
The consultant may if required add the below mentioned optional
accessories / functions.
ñ Remote keyboard.
ñ Dynamic set point program via a 4 20 mA proportional
signal.
ñ BMS module interface kit for modbus connection.
ñ Parallel chiller operation with more than 2 units with optional
controller.
ñ Microprocessor parameters reprogramming card.
ñ Condenser fins made of prepainted aluminum or copper, and
blygold treatment for additional corrosion protection.
ñ Plate exchanger-freezing protection for low chilled water
temperature controlled by microprocessor.
ñ Glycol for low chilled water temperatures.
ñ Pressure relief valve on compressor discharge.
ñ High / low pressure manometers.
ñ Phase sequence phase failure - reverse phase and voltage
monitoring device.
22
Interklima Hydronic systems
SPCA 001-010RSB ñ R407c/Scroll