1 - Seiko I Infotech Inc.

▼Manual paper feeding (cut paper)
Manual paper feeding procedure
1 Set the AUTO SUPPLY mode.
When the PDL setup AUTO SUPPLY mode is set to the CONT or
OPTIMAL mode, paper should be manually fed only for the drawings for
which the data was processed immediately after the paper was fed into the
manual paper feeding unit (this function is called "interrupt manual feeding
function".)
When the PDL setup AUTO SUPPLY mode is the MANUAL mode, paper
should be always fed from the manual paper feeding unit. If no paper has
been fed into the manual paper feeding unit when data is transferred, paper
to be used is indicated on the screen (this function is called "continuous
manual paper feeding function".)
Refer to page 5-12 for details of the AUTO SUPPLY mode.
Chapter 2 Basic operations
2 Load the cut paper.
Cut paper as listed below can be used with this device.
A series fixed form cut paper
Name of fixed
form
Lengthwise length Widthwise length
A0 1189 mm (46.8 inches) 841 mm (33.1 inches)
A1 841 mm (33.1 inches) 594.5 mm (23.4 inches)
A2 594.5 mm (23.4 inches) 420.5 mm (16.6 inches)
A3 420.5 mm (16.6 inches) 297.3 mm (11.7 inches)
A4 297.3 mm (11.7 inches) 210.3 mm (8.3 inches)
A series width cut paper
Width name Paper width Paper length
A0 width 841 mm (33.1 inches)
A1 width
A2 width
A3 width
594.5 mm (23.4 inches)
420.5 mm (16.6 inches)
297.3 mm (11.7 inches)
Max. up to printing length
2-37