1 - Seiko I Infotech Inc.

Replacing the toner
When the toner level runs low, the TONER LED will flash. Although
plots can still be produced under this condition, obtain a new toner
cartridge as soon as possible and replace the toner.
When there is no more toner availabe, the TONER LED will go out, the
ERROR LED will come on, and printing will no longer be possible. The
following message appears on the LCD.
Se t Toner Car t r i dge
Open Lever
If the TONER LED starts flashing or the ERROR massage appears,
replace the toner according to the procedures indicated below.
Chapter 2 Basic operations
◆
◆
When you open the toner door, you will find a “Toner
replacement” label affixed to the inside surface. Refer to this
when replacing toner.
After the TONER LED starts flashing, approximately 50 m of
plots can be produceds at normal size and density.
Note
◆If plots with a high printing rate—such as drawings
containing many solid print areas and inversed (black and
white inverted) drawings—are printed just before the toner
runs out, the toner may be used up and the device may be
damaged.
To avoid such a case, refill toner as soon as possible when
the TONER LED is flashing.
2-19