1 - Seiko I Infotech Inc.
1 - Seiko I Infotech Inc. 1 - Seiko I Infotech Inc.
E How to attach the paper roll ◆ The paper flange ends do not have a designated right or left side. You can attach them to either side. 1 Attach the paper flange to a paper roll. N C L E O P S O E Knob Push in the paper flange ends until they contact the paper roll tube, then secure the flange ends by turning the knob in the “CLOSE” direction. Note ◆If the paper flange knobs are loosely fitted, the paper roll will move adversely to the right and left and negatively affect the drawing. Make sure that the knobs are tightened securely. Label 2 Move the flange guide. The label which is affixed to the inside of the drawer indicates the flange positions for different roll widths. Move the flange guide to match the paper roll size you are using. C L O S N E P O Flange guide 3 Load the paper roll into the drawer. Hold the paper roll so that the end of the paper is positioned at the bottom facing the back of the device. Then align the paper flange to the depressions in the flange guide and gently insert the flange in place. Note ◆Take care not to drop the paper roll while performing these activities. 2-16
▼Replacing paper rolls 4 Insert the end of the paper roll into the paper feed inlet of the device. Turn the paper flange and insert the end of the paper roll so that it is straight. Turn the paper feed knob so that the end of the paper roll projects about 10 cm. Paper feed knob Chapter 2 Basic operations 5 Cut the end of the paper. While holding the end of the paper roll, cut it off with the cutter. The “Paper cutter position” label is affixed to both ends of the space where the cutter blade should be inserted. Insert the cutter blade into the space where the label arrow is pointing. Slide the cutter blade along the space and cut the paper. ◆ The paper can be cut cleanly when the cutter is inserted in a perfectly sideways direction. Caution ◆Take care not to hurt yourself and damage the device when handling the cutter. ◆Handle the cutter blade with care so that you do not break it. ◆When sliding the cutter along the space, take care not to cut the back of your hand on the sides of the paper tray. 2-17
- Page 9 and 10: Warning labels Warning labels are a
- Page 11 and 12: How to read this manual Manual make
- Page 13 and 14: Key/LCD/LED notations [ ] Indicates
- Page 15 and 16: TABLE OF CONTENTS Introduction ....
- Page 17 and 18: Manual paper feeding (cut paper) ..
- Page 19 and 20: Chapter 5 "SETUP" Menu 5-1 Setting
- Page 21 and 22: Chapter 10 "RESET" menu 10-1 Reset
- Page 23: When a print error occurs .........
- Page 26 and 27: Features This device is an electrop
- Page 28 and 29: Operating conditions This section c
- Page 30 and 31: Installation space ■Installation/
- Page 32 and 33: The following roll paper of the wid
- Page 34 and 35: Paper storing precautions are as fo
- Page 36 and 37: Right side/rear side 1 Mai
- Page 38 and 39: NON-PROPORTIONAL Control panel The
- Page 40 and 41: 5 This button turns on/off the powe
- Page 42 and 43: How to read the status displays for
- Page 44 and 45: Warming up display Warmi ng up nnn
- Page 46 and 47: Plotting procedures overview Plotti
- Page 48 and 49: Power on 1 Turn on the Main power s
- Page 50 and 51: Power off When turning the power of
- Page 52 and 53: ■Turning on the power Initial izi
- Page 54 and 55: Online and offline The device is
- Page 56 and 57: If an error message about paper sup
- Page 58 and 59: How to detach the paper rolls 1 Pul
- Page 62 and 63: 6 Close the paper roll drawer. Gent
- Page 64 and 65: Precautions on handling Warning Do
- Page 66 and 67: 3 Close the scanner cover. Stopper
- Page 68 and 69: 8 Pull the lever to the right end.
- Page 70 and 71: Replacing the waste toner bottle Wh
- Page 72 and 73: 3 Remove the waste toner bottle fro
- Page 74 and 75: Replacing the process cartridge Whe
- Page 76 and 77: 2 Take out the Process cartridge. P
- Page 78 and 79: 6 Insert the Process cartridge. To
- Page 80 and 81: Manual paper feeding (cut paper) Th
- Page 82 and 83: 9× 12 series fixed form cut paper
- Page 84 and 85: When feeding the cut paper into the
- Page 86 and 87: Cancel printing Press the [STOP] ke
- Page 88 and 89: Web function startup method 1 The f
- Page 90 and 91: Using paper of new standard series
- Page 92 and 93: Using paper of Chinese standard ser
- Page 94 and 95: Limiting rolls to be used When limi
- Page 96 and 97: Channels and ports This device is e
- Page 98 and 99: Jobs The device manages the receive
- Page 100 and 101: (1) Setup menu Change the settings
- Page 102 and 103: PDL menu The various print paramete
- Page 104 and 105: Printing status Me nu Mo de MENU #S
- Page 106 and 107: Device menu “DEVICE” From the d
- Page 108 and 109: Function menu “FUNCTION” Press
E<br />
How to attach the paper roll<br />
◆<br />
The paper flange ends do not have a designated right or left<br />
side. You can attach them to either side.<br />
1 Attach the paper flange to a paper roll.<br />
N<br />
C<br />
L<br />
E<br />
O<br />
P<br />
S<br />
O<br />
E<br />
Knob<br />
Push in the paper flange ends until they contact the<br />
paper roll tube, then secure the flange ends by<br />
turning the knob in the “CLOSE” direction.<br />
Note<br />
◆If the paper flange knobs are loosely<br />
fitted, the paper roll will move adversely<br />
to the right and left and negatively affect<br />
the drawing. Make sure that the knobs<br />
are tightened securely.<br />
Label<br />
2 Move the flange guide.<br />
The label which is affixed to the inside of the<br />
drawer indicates the flange positions for different<br />
roll widths. Move the flange guide to match the<br />
paper roll size you are using.<br />
C<br />
L<br />
O<br />
S<br />
N<br />
E<br />
P<br />
O<br />
Flange guide<br />
3 Load the paper roll into the drawer.<br />
Hold the paper roll so that the end of the paper is<br />
positioned at the bottom facing the back of the<br />
device. Then align the paper flange to the<br />
depressions in the flange guide and gently insert the<br />
flange in place.<br />
Note<br />
◆Take care not to drop the paper roll<br />
while performing these activities.<br />
2-16