1 - Seiko I Infotech Inc.

▼When an error message appears
(5) File (TWAIN) interface
W
INTERFACE-TW xxxx
xxxx: Error code
Error code Description Measure
1120 TCP is disconnected.
1131
1136
1139
113C
113D
1141
IP address of the device is
not specified correctly.
TCP connection was reset
from the host device.
Host device is not
connected to the socket.
Time out of TCP connection
to the delivery server
TCP connection was rejected
from the host device.
Invalid IP address is
specified to this device or
path control table.
1143 Host device down.
11FF
2100
2103
Any error other than above
occurred in TCP connection
system.
Any error occurred in TCP
connection.
I/O error (R) occurred in
the connection to the host
device.
• Check the connection of relay units (HUB,
etc.) between host and this device and the
UTP cable, and retry the delivery.
• Check that the IP address of the device is
specified correctly.
• There is no problem if the scan data
received by the host device is normal, but if
abnormal, retry the delivery.
• Check the connection of relay units (HUB,
etc.) between host and this device and the
UTP cable, and retry the delivery.
• Check the connection of relay units (HUB,
etc.) between host and this device and the
UTP cable, and retry the delivery.
• Check that scan driver in host operates
normally.
• Check the connection of relay units (HUB,
etc.) between host and this device and the
UTP cable, and retry the delivery.
• Check that the IP address is specified
correctly in respective units and table.
• Operate the host device normally and retry
the delivery.
• Please notify your dealer or our service
center of the displayed error message and
error condition.
• Check the connection of relay units (HUB,
etc.) between host and this device and the
UTP cable, and retry the delivery.
• Check the connection of relay units (HUB,
etc.) between host and this device and the
UTP cable, and retry the delivery.
Chapter 14 Troubleshooting
14-27