1 - Seiko I Infotech Inc.

FORMAT PARAM. (HP-GL DSCAN only)
These are parameters that you need to set the HP-GL format and DSCAN
format analysis conditions.
■PRT DRIVER (HP-GL only)
Allows for choosing whether or not to use the printer driver. When the
printer driver is operated together with another driver, this setting should
be ENABLE. Even when the printer driver for LP-1010 is set to the
PANEL FIRST mode, this can be set to ENABLE without causing a
problem. This setting is performed on the third hierarchy.
: Default value
ENABLE Choose this parameter when using the supplied printer driver
for LP-1010. In this case, the setup you made with the panel
may not be used for operation.
When data is received from a driver other than the printer
driver for LP-1010 in this setting, setup for this device is
enabled.
DISABLE When the printer driver is operated in the PANEL SETUP
using the printer driver for LP-1010, this setting should be
used.
CHINA
This parameter should be set up when printing the roll of the
China series on the printer driver for LP-1010. In this case, the
roll can be operated without using the setup.
In this setting, the driver output data selects automatically the
roll of China series and operation for the actual size plotting
becomes possible.
When data is received from a driver other than the printer
driver for LP-1010, the setup is enabled.
Note
◆ The default value varies depending on the setting in the
INITIAL SETTING.
5-24