1 - Seiko I Infotech Inc.

▼Setting parameter items
SUPPLY PARAM.
■CENTERING
Aligns a drawing to the center of the paper. (See the figure below.)
This setting is found on the third hierarchy.
: Default value
OFF
Centering is not performed.
ON
Centering is performed.
For the data which cannot be completely saved in the spool memory,
centering is not available.
Centering OFF
Centering ON
Y
X
Drawing
Y
a
X
b
Drawing
b
a
Chapter 5 "SETUP" Menu
Paper feed
direction
Cut position
Paper feed direction Cut position
a: Varies depending on output drawing.
b: Varies depending on output drawing.
Drawing is positioned at the center of paper.
■PAPER TYPE
Allows for setting of the type of paper to be used in the paper feed mode
= continuous mode or optimum mode. This setting is found on the
second hierarchy.
: Default value
NON-DESIGNATED Paper type is not specified.
NORMAL PAPER Allows for normal paper feeding.
TRACING PAPER Allows for tracing paper feeding.
FILM
Allows for film feeding.
5-15