Download - Industrial and Bearing Supplies

LED BUGGY WHIPS
ACCESSORIES
70
LED Buggy Whip
LED Buggy Whip
1.2 metre HM4612
2.0 metre HM4620
3.0 metre HM4630
MULTI
VOLT
IP6K7
LED
200G
DT
0.5Kg
12V
1W
To meet safety regulations, mine
sites often require light vehicles
to display high visibility safety
flags to
improve visibility for drivers of
heavy machinery. Mounting onto
the bumper bars of light vehicles,
these give vehicles an extra layer
of protection.
During night and poor visibility
levels the operation of light
vehicles generally requires the
use of rotating safety beacons to
improve visibility. However in mine
sites where the topological surface
contains large dips and hills, these
may not be adequate.
By combining a bright LED with a
long reflective safety flag, drivers
of light vehicles can ensure they
are always in the line of sight of
heavy machinery.
The LED module puts negligible
load on the vehicles electrical
system (less than 1W), the
shaft is constructed from a high
quality fiberglass rod, sealing
the electrical components from
weather damage. The flag mounts
to the vehicle via a quality quick
release latch allowing the flag to
be taken down when the vehicle
is off site. The cable is terminated
with a DT plug, allowing quick
removal whilst sealing the electrics
from environmental damage.
The flag contains reflective UV
resistant material and the nylon
material repels the high levels of
dirt and dust often encountered in
mine sites.
9.HM46FX
Technical Specifications:
Light source
Quality LEDs in BA9 bulb
holder
Voltage 12V
Power Consumption
< 1W
Length
1.2 metres, 2.0 metres or
3.0 metres
Mounting
Integrated mounting
bolt on base with snap
on/off quick-release
shaft for quick and
easy installation
Spare Parts:
9.HM46MP
Male Pin Connector for Quick
Release
9.HM46MS
Medium Spring
9.HM46GL
LED Globe
9.HM46MP
9.HM46MS
9.HM46FX
Replacement Reflective Cross
Flag
Snap On/Off Quick Release