Scottsdale Fashion Square - Macerich

More documents

Recommendations

Info

Scottsdale Fashion Square Phase 10-Barney’s Expansion 7014 E. Camelback Road, Scottsdale, AZ 85251 ELECTRICAL CRITERIA (Cont’d.) 5. 6. 7. 8. 9. All fan coils must be 480 volt, 3-phase and be ant’s space. Tenant is responsible for providing branch circuit (s) to 480 volt, 3 phase fan coil The Tenant’s electrical contractor must provide - Tenant’s space. This breaker must have a lock ing. Restroom toilet exhaust fans must be tied to An electrical load calculation form can be found in the appendix of this handbook. The form must be complete and submitted to Landlord sections (s). The service utility is Salt River source available in the tenant spaces. The isolated, and does not have “transient voltage surge suppression” equipment. Maximum Loads Loads in general shall be governed by the local Energy Codes, and per City, State, IBC/IEC and Tenant Design Criteria Updated: September, 2008 - is available from the Landlord via the utility or the Tenant distribution panelboard. Landlord shall provide such service upgrades at cost (including engineering and related overhead expenses) to be reimbursed by the Tenant. Telephone Service Tenant shall make application to the serving tele- their requirments. demised premises to Landlord’s main telephone lord using Landlord’s designated contractor. Tenant shall extend conduit to the Landlord’s backboard Lighting (See Lighting Requirements outlined in Section II Architectural design Criteria.) Tenant is responsible for lighting system control, including connection to the Building Management system and connection to the Fire Alarm system. All emergency lighting, exit signs, horns and strobes must be provided by Tenant as required by code. Wire and Disconnect Sizing ment or the Tenant distribution panelboard shall be sized to meet the calculated demand load requirements of the Tenant space and minimum overcurrent protection rating of the circuit breaker equipment or Tenant distribution panel. Current limiting circuit breakers are not permitted. The circuit breaker shall be purchased and installed by a Landlord’s approved Electrical Coordinator at the Tenant’s expense. The circuit breaker may not breaker device for applicable Tenant distribution panelboard or utility service entrance equipment. as required to accommodate any voltage drop approved Electrical Contractor to complete feeder termination at panelboard. The Tenant shall provide the distribution to Tenant loads. This can be in the the main Tenant panel. Tenant General Contrac- approved electrician to supply and install circuit breaker and complete feeder termination at Scottsdale Fashion Square panel board. Due to the high available interrupting currents (AIC) present at the Landlord’s I-Line (type) Tenant dis- V. Technical Criteria 42
Scottsdale Fashion Square Phase 10-Barney’s Expansion 7014 E. Camelback Road, Scottsdale, AZ 85251 ELECTRICAL CRITERIA (Cont’d.) can choose to: 1. 2. Have the landlord provide at the Tenant’s expense a circuit breaker in the Tenant distribu- Provide an overcurrent protection device at the Tenant main disconnecting means that is U.L. the upstream circuit breaker provided in the Landlord’s Square D I-Line Tenant distribution panelboard. All circuit breakers in the Tenant distribution panelboards are Square D Type EG, FG, KH, LH, EJ, FC, FJ, KC, LC, or LX (or equal by G.E.) as applicable per the required Tenant circuit breaker size and available short circuit current at each Tenant distribution panelboard. Tenant may use a Square D type EDB or EGB circuit breaker to achieve a series cal Engineer, Square D, or G.E. as appropriate. - Materials Materials, products and equipment including all Code and other applicable codes; and shall be Tenant Design Criteria Updated: September, 2008 exterior elements or required by codes shall be - Conduit or electrical metallic tubing. Conductors/Wiring - BX, Romex MC or any other armored or metal clad - 60 degrees Celsius shall be THW or THWM of high coded insulation per code. recommendations. Panelboards Circuit breakers shall be thermal magnetic type and of the common pull type. Distribution panelboards, utilizing automatic circuit breakers. Cabinets shall be constructed of code gauge sheet steel door and trim. All panelboards shall door enclosure single piece assembly. Panelboard bussing shall be cooper tin-plated aluminum. All Tenant Space (including Kiosks) unless permitted Transformers level Class H. Devices Floor Boxes lord or the Landlord’s Structural Engineer. Grounding Tenant’s electrical system shall be grounded to V. Technical Criteria 43
Page 1 and 2: Scottsdale Fashion Square Phase 10-
Page 41: Scottsdale Fashion Square Phase 10-
Page 49: Scottsdale Fashion Square Phase 10-

Scottsdale Fashion Square - Macerich

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?