Scottsdale Fashion Square - Macerich

More documents

Recommendations

Info

Scottsdale Fashion Square Phase 10-Barney’s Expansion 7014 E. Camelback Road, Scottsdale, AZ 85251 INTERIORS (Cont’d.) All ceilings, related framing, blocking and accessories shall be noncombustible. No com- ceiling surfaces. Lighting Lighting can greatly contribute to the design of a Tenant’s store, emphasizing architectural forms, highlighting signage, and adding color and visual creative use of dramatic lighting is encouraged at The DCA of the Tenant space must employ in DCA. Fixtures must be positioned so that bright glare is not directed onto the public areas. recessed. may be used only in concealed areas and/or a maximum size of 2’ x 2’ and have silver label. Concealed light coves to highlight architec- encouraged. Wall sconces may be used to cast light onto storefront forms, provided that bare bulbs are - to be submitted if this light form is used. front design concept. Fixture cut sheets must by Landlord. Tenant is responsible for main- Premises. conservation and building codes. No strobe, spinner or chase type lighting shall be used. adequately lit and ventilated. Direct visual cent tubes is prohibited. Walls/Partitions Tenants and/or Tenant and exit/service corri- 5/8” interior mechanically fastened steel studs tenancies, (provided by Landlord), and 5/8”, bottom of roof deck, or deck above (or as required by governing code) on each side (provided by Tenants). At Landlord’s option, demis- not designed to accommodate cantilevered or eccentric loads. If Tenant plans to use a tional steel studs or independent supports for the shelf standards. No plumbing, electrical, or telephone lines or height of eight and a half feet (8 1/2’) on the the back door. - insulated to achieve a minimum STC rating Tenant Design Criteria Updated: September, 2008 II. Architectural Design 22
Scottsdale Fashion Square Phase 10-Barney’s Expansion 7014 E. Camelback Road, Scottsdale, AZ 85251 INTERIORS (Cont’d.) noise, (including but not limited to music stores, arcades, etc.) at the Landlord’s discretion. The required. shops and all food preparation type Tenants: a. resistant 5/8” type “x” gypsum board. b. have sheet metal installed on studs, layers of 5/8” type “X” gypsum board to Tenants side of studs. Stockroom Partitions. When Tenant chooses room, Tenant shall extend the partition separating the stockroom from other areas of the store, to the underside of the structure above in order to isolate the stockroom from the sales area attic space. Wall Finishes. Metal or plastic laminate inserts are required mounted systems. Floor and Wall Base - the entire DCA, including any permitted pop out areas. Carpet, vinyl or rubber materials of any resistant surface. Ceramic, quarry and stone tile installations face. Carpet must be commercial grade and must areas. Note: Carpet may not be used at the Sheet or modular vinyl may be used in support or stock rooms not visible from the sales area. Tenants shall install vinyl composition tile in ishes must be submitted for approval and included in Tenant’s preliminary submissions. Toilet Room Requirements Toilet facilities shall be designed in compliance Codes. Each restroom must have an exhaust system. - Tenant Design Criteria Updated: September, 2008 II. Architectural Design 23
Page 1 and 2: Scottsdale Fashion Square Phase 10-
Page 21: Scottsdale Fashion Square Phase 10-
Page 49: Scottsdale Fashion Square Phase 10-

Scottsdale Fashion Square - Macerich

Create successful ePaper yourself

Delete template?

Save as template?