Starline Busway Catalog - Power & Systems Innovations

B60 Busway Series
7
B60 Busway Parts
Hangers
B60 Busway features the
convenience of a continuous
hanger access slot. This allows
hanger support anywhere along
the busway run. Typical hanger
support spacing is 10 feet
maximum.
The standard hanger, type
THB-3 fits in the mounting slot
in the top of the busway. It has
a 3/8 - 16 by 1 inch stud for
rigid mount. It can be inserted
in the middle of a busway
section, with its twist-in design.
Type RHB-3 is designed for fastening
to all thread rods. A 3/8
inch rod coupler, lock washer
and square cinch plate are added
to the standard hanger.
The weight hook ring, catalog
number WHR-1, can be used as
a hanger for suspending the
busway from chains or cables.
It is also used to hang loads up
to 50 pounds under the busway,
such as light fixtures, tools, and
balancers. It can be attached to
the top or bottom channel of
the busway housing. The ACH-1
and ACH-2 aircraft cable hanger
assembly includes a B100 hanger
plate, and an easy grip clamp
assembly for steel cable. Cable is
not included.
The T-bar hanger clip is used to
mount the busway system to the
inverted T-bar of a drop ceiling,
just below the ceiling tiles. The
clip locks onto the T-bar and the
busway fastens to the stud on
the clip. The T-bar must be
adequately anchored to the
building. Not recommended for
heavy loads.
Hanger Designs
Catalog # Description Weight
THB-3 twist-in hanger 0.2 lb
RHB-3 rod mount hanger 0.3 lb
WHR-1 weight hook ring 0.2 lb
THB-4 T-bar mounting hanger 0.1 lb
ACH-1
cable suspension hanger assembly,
1/16” cable 0.3 lb
ACH-2
cable suspension assembly,
3/32” cable 0.3 lb
THB-1/4 hanger with 1/4” stud 0.2 lb
THB-3 RHB-3 ACH-1
WHR-1
For an authorized dealer or more information call toll free 800-333-3490 or 412-221-4400