INSTRUCTION MANUAL FOR SEWING MACHINE - Singer - This Wiki
INSTRUCTION MANUAL FOR SEWING MACHINE - Singer - This Wiki INSTRUCTION MANUAL FOR SEWING MACHINE - Singer - This Wiki
as shown at side. etc., more easily. converts to free arm macnine by arrow. 1 Hold the left end of table FREE-ARM SEWiNG REMOVING EXTENSION TABLE —5— 2. Especially useful for sewing 1. This sewing machine can be used 3. To sew tubular ust sliø the sleeve as a fiat bed machine out easily removing the extension table. sleeves, pal-it legs, tubular faDr:cs or leg of pants on to the free arm and pull out in dIrection or
I WINDING ThE BOBBIN 1 .elease stop motion knob. 2.Thread as shown. 3.When bobbin s filled, tighten stop motion knob. 5cm thread 7’ThcbbIn N winder spindle -. Push bobbin winder spindle in direction of arrow. When bobbin winding is com pleted return spindle to original position. x ;:j> x When bobbin winding is in correct, release the screw of upper thread guide and ad Just U or down until bobbin winding is balanced. —6—
- Page 1 and 2: i H SEWING MACHINE INSTRUCTION MANU
- Page 3 and 4: CONTENTS Names of Parts............
- Page 5 and 6: Hand wheel Motion knob Stop clamp B
- Page 7: BEFORE SEWING 1. Fit plug into the
- Page 11 and 12: —8— latch onto centre pin in sh
- Page 13 and 14: needle qoes down and slcwiy towards
- Page 15 and 16: ADJUSTING THREAD TENSION Corec Weak
- Page 17 and 18: Needle clamp screw CHANGiNG NEEDLE
- Page 19 and 20: — !i5 — after stopping sewing.
- Page 21 and 22: 2 The zig-zag presser foot can be u
- Page 23 and 24: Select stralgnt stItch. ZIPPER SEWI
- Page 25 and 26: I ThVIN NEEDLE Note: Twin needle ca
- Page 27 and 28: — 24 — 4 it (4) FIGURE (4). UND
- Page 29: Machine Stitch - - - - Incorrect -
I<br />
WINDING ThE BOBBIN<br />
1 .elease stop motion knob.<br />
2.Thread as shown.<br />
3.When bobbin s filled,<br />
tighten stop motion knob.<br />
5cm thread<br />
7’ThcbbIn N<br />
winder<br />
spindle -.<br />
Push bobbin winder spindle in<br />
direction of arrow.<br />
When bobbin winding is com<br />
pleted return spindle to<br />
original position.<br />
x<br />
;:j><br />
x<br />
When bobbin winding is in<br />
correct, release the screw of<br />
upper thread guide and ad<br />
Just U or down until bobbin<br />
winding is balanced.<br />
—6—