INSTRUCTION MANUAL FOR SEWING MACHINE - Singer - This Wiki
INSTRUCTION MANUAL FOR SEWING MACHINE - Singer - This Wiki INSTRUCTION MANUAL FOR SEWING MACHINE - Singer - This Wiki
— 21 HEMMING Note. Hemmer foot can be purchased separately. 1. Raise the foot and the needle to its highest position. Replace the foot with the 2. Fold over the fabric edge by about 3mm and place it under the foot. Secure tne 3. Lower the foot and sew the hem. 4. Durning sewing, fold the fadric to the left a little and allow it to run into the 5. Make sure that the facric does not move under the right half or the foot, The Only suitable materials can be used and some practice may be necessary to acneive best results. hemmer foot. folded edge with a few stitches. Take out the workplece and draw the hem into the hemmer foot by pulling the threads. hemmer foot. fabric must be fed into the scroll of the hemmer sutficently so that the work piece edge runs freely through the groove under the foot. —
I ThVIN NEEDLE Note: Twin needle can be purchased separately same oath as for normal sewing. Seøarate threads before last thread guide above the needle. Insert one thread into the right needle of twin needle. Insert other thread into the left needle of twiii needle. cause breaking of needle. emove regular needle and insert twin needle. Thread both threads througn me CAUTTON:Do not set stitch width wider than number 2 setting. Exceeding this will EMBROIDERY Lower feed dog and move hooped fabric slowly to form the desired effect. See Page 13 drop teed —22—
- Page 1 and 2: i H SEWING MACHINE INSTRUCTION MANU
- Page 3 and 4: CONTENTS Names of Parts............
- Page 5 and 6: Hand wheel Motion knob Stop clamp B
- Page 7 and 8: BEFORE SEWING 1. Fit plug into the
- Page 9 and 10: I WINDING ThE BOBBIN 1 .elease stop
- Page 11 and 12: —8— latch onto centre pin in sh
- Page 13 and 14: needle qoes down and slcwiy towards
- Page 15 and 16: ADJUSTING THREAD TENSION Corec Weak
- Page 17 and 18: Needle clamp screw CHANGiNG NEEDLE
- Page 19 and 20: — !i5 — after stopping sewing.
- Page 21 and 22: 2 The zig-zag presser foot can be u
- Page 23: Select stralgnt stItch. ZIPPER SEWI
- Page 27 and 28: — 24 — 4 it (4) FIGURE (4). UND
- Page 29: Machine Stitch - - - - Incorrect -
— 21<br />
HEMMING Note. Hemmer foot can be purchased separately.<br />
1. Raise the foot and the needle to its highest position. Replace the foot with the<br />
2. Fold over the fabric edge by about 3mm and place it under the foot. Secure tne<br />
3. Lower the foot and sew the hem.<br />
4. Durning sewing, fold the fadric to the left a little and allow it to run into the<br />
5. Make sure that the facric does not move under the right half or the foot, The<br />
Only suitable materials can be used and some practice may be necessary to acneive<br />
best results.<br />
hemmer foot.<br />
folded edge with a few stitches. Take out the workplece and draw the hem<br />
into the hemmer foot by pulling the threads.<br />
hemmer foot.<br />
fabric must be fed into the scroll of the hemmer sutficently so that the work<br />
piece edge runs freely through the groove under the foot.<br />
—