INSTRUCTION MANUAL FOR SEWING MACHINE - Singer - This Wiki

More documents

Recommendations

Info

—.7— spnng slot. SLOT Hinged latch REMOVING BOBBIN CASE AND BOBBiN 1 .Ralse needle to Its highest INSERTING BOBBIN INTO BOBBIN CASE 1.Pull off 5cm of thread from position and open the shuttle race cover. bobbin and insert it into bobbin case as shown. 3.elease the latch and bob 3.Pull into slot and under bin will fail out easily. tension spring and draw out about 10cm of thread. 2. Open hinged latch of bobbin 2.Guide the end of thread into case and pull bobbin case out of machine.
—8— latch onto centre pin in shuttle and release 2.Hoiding latch open, place bobbin case latch of bobbin case and hold it. pulling thread to the front, open the 1 ,Rase needle to its highest position, INSERTiNG BOBBIN CASE INTO SHUTTLE RACE
Page 1 and 2: i H SEWING MACHINE INSTRUCTION MANU
Page 3 and 4: CONTENTS Names of Parts............
Page 5 and 6: Hand wheel Motion knob Stop clamp B
Page 7 and 8: BEFORE SEWING 1. Fit plug into the
Page 9: I WINDING ThE BOBBIN 1 .elease stop
Page 13 and 14: needle qoes down and slcwiy towards
Page 15 and 16: ADJUSTING THREAD TENSION Corec Weak
Page 17 and 18: Needle clamp screw CHANGiNG NEEDLE
Page 19 and 20: — !i5 — after stopping sewing.
Page 21 and 22: 2 The zig-zag presser foot can be u
Page 23 and 24: Select stralgnt stItch. ZIPPER SEWI
Page 25 and 26: I ThVIN NEEDLE Note: Twin needle ca
Page 27 and 28: — 24 — 4 it (4) FIGURE (4). UND
Page 29: Machine Stitch - - - - Incorrect -

INSTRUCTION MANUAL FOR SEWING MACHINE - Singer - This Wiki

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?