dewoitine d.520 assembly manual

More documents

Recommendations

Info

DEWOITINE. Instruction Manual. Hinge. Note: Work the aileron up and down several times to “work in” the hinges and check for proper movement. HINGING THE RUDDER. Glue the rudder hinges in place using the same techniques used to hinge the ailerons. 5) Turn the wing panel over and deflect the aileron in the opposite direction from the opposite side. Apply thin C/A glue to each hinge, making sure that the C/A penetrates into both the aileron and wing panel. 6) Using C/A remover/debonder and a paper towel, remove any excess C/A glue that may have accumulated on the wing or in the aileron hinge area. 7) Repeat this process with the other wing panel, securely hinging the aileron in place. Hinge. AILERON CONTROL HORN Aileron control horn: See pictures below. 2 sets. 3x40mm. 8) After both ailerons are securely hinged, firmly grasp the wing panel and aileron to make sure the hinges are securely glued and cannot be pulled out. Do this by carefully applying medium pressure, trying to separate the aileron from the wing panel. Use caution not to crush the wing structure. Aileron contronl horn . 4
www.seagullmodels.com CONTRONL HORN M3 SCREW. CONTROL HORN M3 SCREW. ALUMINUM WASHER. Epoxy. Epoxy. ALUMINUM WASHER. Wing Flap. Wing ALUMINUM WASHER. 18mm. Epoxy. M3 lock nut. M3 LOCK NUT. ALUMINUM WASHER. Wing 18mm. Epoxy. Flap contronl horn . FLAP CONTROL HORN. Install the flap control horn using the same method as with the aileron control horns. 2 sets. ELEVATOR CONTROL HORN. Install the elevator control horn using the same method as with the aileron control horns. 2 sets. 3x45mm. 3x45mm. CONTRONL HORN M3 SCREW. CONTRONL HORN M3 SCREW. Aluminum Washer. Epoxy. Aluminum Washer. Epoxy. Wing. Flap. Elevator. Aluminum Washer. M3 LOCK NUT. Aluminum Washer. M3 LOCK NUT. 5
Page 1 and 2: DEWOITINE D.520 MS:99 ASSEMBLY MANU
Page 3: www.seagullmodels.com NOTE: To avoi
Page 7 and 8: www.seagullmodels.com Vent tube. Fu
Page 9 and 10: www.seagullmodels.com Aluminum spac
Page 11 and 12: www.seagullmodels.com INSTALLING TH
Page 15 and 16: www.seagullmodels.com PUSHROD INSTA
Page 17 and 18: www.seagullmodels.com INSTALLING VE
Page 19 and 20: www.seagullmodels.com ELEVATOR - RU

dewoitine d.520 assembly manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?