Progetto1:Layout 1 - Urmet

Progetto1:Layout 1 - Urmet Progetto1:Layout 1 - Urmet

18.01.2015 Views

VIDEO TRANSMISSION 1092/304 1092/316 1092/304 Active balun video receiver (4 channels) Active balun video receivers (with signal amplification) allow to adapt the impedance between coax and UP cable. They are particularly suitable for receiving up to 4 video signals (black and white or colour) on UP (Unshielded Twisted Pair) wires. Suitable for use with passive transceiver 1092/300 or active transmitter 1092/302. - Compact dimensions for rapid connection to video control apparatuses, monitors and cameras. - 4 BNC female outputs, terminal board and RJ45 connector for UTP CAT5 wire input - Very easy to use - Video signal equalisation dip switch (definition and contrast) on each channel - Video signal level adjustment potentiometer (brightness) on each channel - Double impedance and interference filter for ensuring better protection from interference. - UTP signal input on terminal board or RJ45 connector - Ready to be wall-mounted. - Power 12Vdc - max 80 mA (power unit not included). 1092/316 Active balun video receiver (16 channels) Active balun video receivers (with signal amplification) allow to adapt the impedance between coax and UP cable. They are particularly suitable for receiving up to 16 video signals (black and white or colour) on UP (Unshielded Twisted Pair) wires. Suitable for use with passive transceiver 1092/300 or active transmitter 1092/302. - Compact dimensions for rapid connection to video control apparatuses, monitors and cameras. - 16 BNC loop-through female outputs and 4 RJ45 connectors for UTP CAT5 wire input - Very easy to use - Video signal equalisation dip switch (definition and contrast) on each channel - Video signal level adjustment potentiometer (brightness) on each channel - Double impedance and interference filter for ensuring better protection from interference. - Signal input available on RJ45 connector - 230Vac power 230 •

CCTV WIRELESS REMOTE WAVE VIDEO TRANSMISSION 1094/001T 1094/001R 1094/050 1094/001T REMOTE WAVE series 2.4 GHz wireless video transmitter - Output power level: 100mA max. - Video input: 1Vpp @75ohm to RCA connector; - Audio input: 1Vpp @600ohm to RCA connector - Power: 12Vdc / 300 mA 1094/001R REMOTE WAVE series 2.4 GHz wireless video receiver - Sensitivity: -85dbm - Video output: 1Vpp @75ohm to RCA connector and BNC - Audio output: 1Vpp @600ohm to RCA connector - Video resolution: Max. 400TVL - Power: 12Vdc / 300 mA 1094/050 REMOTE WAVE series panel antenna - Frequency range: 2400~2500 MHz - Impedance: 50 ohm - Gain: 8 dBi - Polarisation: vertical - Directivity: horizontal lobe 60°, vertical lobe 50° - Terminal: SMA male connector - Dimensions: 175 (W) x 120 (H) x 28 (D) mm 1094/051 REMOTE WAVE series stylus antenna - Frequency range: 2400~2500 MHz - Impedance: 50 ohm - Gain: 7 dBi - Polarisation: vertical - Directivity: omnidirectional - Terminal: SMA male connector - Dimensions: 310 (H) x 60 Ø mm REMOTE WAVE series is recommended for installations in free space with range not exceeding 100 m. CCTV Coax Coax 1094/051 Coax Coax Coax Coax Coax Coax NOTE: the Remote Wave system works in the ISM 2.4 GHz radiofrequency range, the same of Wi-Fi and Bluetooth devices, audio video repeaters, microwave ovens. etc. These devices may therefore interfere with the system. Follow the instructions contained in the instruction manual for correct operation. • 231

CCTV<br />

WIRELESS REMOTE WAVE VIDEO TRANSMISSION<br />

1094/001T<br />

1094/001R<br />

1094/050<br />

1094/001T REMOTE WAVE series 2.4 GHz wireless video transmitter<br />

- Output power level: 100mA max.<br />

- Video input: 1Vpp @75ohm to RCA connector;<br />

- Audio input: 1Vpp @600ohm to RCA connector<br />

- Power: 12Vdc / 300 mA<br />

1094/001R REMOTE WAVE series 2.4 GHz wireless video receiver<br />

- Sensitivity: -85dbm<br />

- Video output: 1Vpp @75ohm to RCA connector and BNC<br />

- Audio output: 1Vpp @600ohm to RCA connector<br />

- Video resolution: Max. 400TVL<br />

- Power: 12Vdc / 300 mA<br />

1094/050 REMOTE WAVE series panel antenna<br />

- Frequency range: 2400~2500 MHz<br />

- Impedance: 50 ohm<br />

- Gain: 8 dBi<br />

- Polarisation: vertical<br />

- Directivity: horizontal lobe 60°, vertical lobe 50°<br />

- Terminal: SMA male connector<br />

- Dimensions: 175 (W) x 120 (H) x 28 (D) mm<br />

1094/051 REMOTE WAVE series stylus antenna<br />

- Frequency range: 2400~2500 MHz<br />

- Impedance: 50 ohm<br />

- Gain: 7 dBi<br />

- Polarisation: vertical<br />

- Directivity: omnidirectional<br />

- Terminal: SMA male connector<br />

- Dimensions: 310 (H) x 60 Ø mm<br />

REMOTE WAVE series is recommended for installations in free space<br />

with range not exceeding 100 m.<br />

CCTV<br />

Coax<br />

Coax<br />

1094/051<br />

Coax<br />

Coax<br />

Coax<br />

Coax<br />

Coax<br />

Coax<br />

NOTE: the Remote Wave system works in the ISM 2.4 GHz radiofrequency range, the same of Wi-Fi<br />

and Bluetooth devices, audio video repeaters, microwave ovens. etc. These devices may therefore interfere<br />

with the system. Follow the instructions contained in the instruction manual for correct operation.<br />

• 231

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!