Progetto1:Layout 1 - Urmet

CCTV
1092/301
1092/302
1092/303
1092/301 Passive balun TX/RX video pair with remote power supply
Passive balun videos (without signal amplification) with remote camera power
connectors adapt the impedance between coax and UP cable. They are particularly
suited for transmitting and receiving video signals (either black and white or
colour) and remotely powering on UTP (Unshielded Twisted Pair) wire.
- Compact dimensions for rapid connection to video control apparatuses,
monitors and cameras.
- 1 BNC video input and RJ45 connector for connecting to UTP CAT5 wire
- Very easy to use
- No power needed by the device
- Remote power input/output.
- Double impedance and interference filter for ensuring better protection
from interference.
- Pair of transceivers included.
1092/302 Active balun video transmitter (1 channel)
Active balun video transmitters (with signal amplification) for adapting impedance
between coax and UP cable. They are particularly suitable for transmitting video
signals (black and white or colour) on UP (Unshielded Twisted Pair) wires for
distances further than 1200 metres.
Suitable for use with active receivers 1092/303, 1090/304 or 1092/316.
- Compact dimensions for rapid connection to video control apparatuses,
monitors and cameras.
- 1 BNC video input (female) and terminal board for connecting to UTP CAT5 wire
- Very easy to use
- Signal amplification gain level adjustment and three-level signal transmission.
- Double impedance and interference filter for ensuring better protection
from interference.
- Ready to be wall-mounted.
- Power 12Vdc - max 80 mA (power unit not included).
1092/303 Active balun video receiver (1 channels)
Active balun video receivers (with signal amplification) adapt the impedance
between coax and UP cable. They are particularly suitable for receiving video
signals (black and white or colour) on UP (Unshielded Twisted Pair) wires
on distances further than 1200 metres.
Suitable for use with passive transceiver 1092/300 or active transmitter 1092/302.
- Compact dimensions for rapid connection to video control apparatuses,
monitors and cameras.
- 1 BNC video output (female) and terminal board for connecting to UTP CAT5 wire
- Very easy to use
- Video signal equalisation dip switch (definition and contrast).
- Video signal level adjustment potentiometer (brightness).
- Double impedance and interference filter for ensuring better protection
from interference.
- Ready to be wall-mounted.
- Power 12Vdc - max 80 mA (power unit not included).
CCTV
• 229