Progetto1:Layout 1 - Urmet

Progetto1:Layout 1 - Urmet Progetto1:Layout 1 - Urmet

18.01.2015 Views

TELEPHONE INTERFACES Communicate anytime, anywhere Save money on telephone calls Simple installation Flexible management The device to help you save money Telephone interfaces are devices which allow to connect telephone terminals to other equipments or communication networks. Specifically, we have door phone/telephone interfaces for door phone system applications, “GSM/GPRS” interfaces for using the GSM network and “Telephone loudspeaking units” for integrating any telephone switchboard (PABX) with a “Sinthesi” loudspeaking unit. Each interface can offer various integration needs. Domus Cell GSM network Analogue telephone 142 •

TELEPHONE INTERFACES Door phone/telephone interfaces This device is used to allow communication, also at the same time, with a dial line and a loudspeaking unit using a single telephone and allowing to open the door. With a cordless phone, you can take incoming calls from anywhere in your home, e.g. from the garden, the balcony or the loft. Specifically, the new door phone interface 1332/40 offers various installation solutions: direct power from loudspeaking unit, management of two door units, door unit call confirmation tone, etc. 1332/40 1072/67 1332/40 Door phone/telephone interface Interface device for telephone lines and door phone systems and replaces the 1332/30. One device connected to an analogue dial line and 4+n door phone system (this device must be connected to other dedicated interfaces). Allows to manage telephone and door phone calls to a single telephone terminal. Set up for connecting to two loudspeaking units and equipped with two relays for opening the door or for auxiliary services. Supplies power (+6Vdc) to a PE and different operating modes, programmable directly from the connected phone. Power: 12 Vac. Minimum consumption: 3/10VA. Installation: DIN bar. Dimensions: 108 (W) x 90 (H) x 55 (D) mm (6 DIN modules). 1072/67 Bibus PABX interface. Wall-mounted installation For using Scaitel Agorà PABX in Bibus systems and maintaining the original functions (door phone call and conversation, concierge switchboard call and conversation, door opening, special services, floor call). 1038/67 Digivoice/4+n voice adapter Wall-mounted installation. Consumption: 2.5 mA. For using Agorà Urmet Domus switchboards in an apartment. Manages “4+n” audio output and may be connected to telephone switchboard or used in a mixed Digivoice and “4+n” system. 955/67 PABX interface for “1+1” audio and 5-wire video systems The device is used to connect a Scaitel PABX switchboard to a 5 wire video or “1+1” audio system and to manage all services connected to the audio/video system: calls, conversations between telephone and loudspeaking unit, door opening. Dimensions: 125 (W) x 100 (H) x 40 (D) mm. Input voltage: > 2.5Vac. Voltage during operation: 5.9V @ 25 mA. 1082/67 2GO! interface. Installation on 6 DIN module bar Connected to 2GO! riser column (by means of one-user distributor Ref. 1082/51 to be purchased separately) supplies typical 4+n signal outputs (1 - 2 - CA - 6 - 9) for connecting to any PABX. Video signal output on coax base band to terminals V3-V5 for connecting any non-coax 4+n brackets. This allows the following solutions: connection of Utopia speaker with 1703/91 bracket and 1703/2 monitor; connection of one or two monitors with coax bracket in apartment, while in 2GO! system the apartment is seen as a single device; PABX with telephones and video modules; connection to a relay 788/1 and a one-family kit with coax for floor calls by video loudspeaking unit. Dimensions: 108 (W) x 90 (H) x 61 (D) mm. TELEPHONY • 143

TELEPHONE INTERFACES<br />

Communicate anytime, anywhere<br />

Save money on telephone calls<br />

Simple installation<br />

Flexible management<br />

The device to help you save money<br />

Telephone interfaces are devices which allow<br />

to connect telephone terminals to other equipments<br />

or communication networks.<br />

Specifically, we have door phone/telephone<br />

interfaces for door phone system applications,<br />

“GSM/GPRS” interfaces for using the GSM network<br />

and “Telephone loudspeaking units” for integrating<br />

any telephone switchboard (PABX) with a “Sinthesi”<br />

loudspeaking unit. Each interface can offer various<br />

integration needs.<br />

Domus Cell<br />

GSM network<br />

Analogue telephone<br />

142 •

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!