User's Manual - Exemys

SGW1-MB-NM User’s Manual
Exemys
After powering the device on you should see this welcome message.
SGW1-MB-NM NMEA to Modbus converter - Exemys (1.0):
--------------------------------------------------
>
Typing the following commands you will be able to configure the Modbus and NMEA serial ports.
After each command type : and the desired value.
MBBAUD
MBPARITY
MBTYPE
MBID
MBPKTTOUT
NMEABAUD
NMEAPARITY
NMEABITS
NMEASEND
NMEALISTEN
NMEAVERB
FACTRESET
LIST
HELP
Modbus port Baud rate
1200,2400,4800,9600,14400,19200,28800,33600,38400,57600,115200
Modbus port Parity
N for none, E for even, O for odd
Modbus type
R for RTU, A for ASCII
Modbus slave ID
1 to 247
Modbus RTU packet time out (don’t change this value unless you know exactly what
it means)
3 to 50
NMEA port Baud rate
1200,2400,4800,9600,14400,19200,28800,33600,38400,57600,115200
NMEA port Parity
N for none, E for even, O for odd
NMEA port data bits
7,8
Send a direct message to the NMEA device (use it to configure your NMEA device)
Type the desired message alter the colons
Enables NMEA to console pass through (all NMEA sentences received will be
repeated on the console port, use it for initial setup)
Enables NMEA parsing verbose (You will see on the console all the parsed values
each time the devices receives an NMEA sentences)
Sets the device to factory defaults
Lists the configuration
Display all the available console’s commands
www.exemys.com R4 8