Proline Promass 83E/F/O Description of Device Functions - FMC ...
Proline Promass 83E/F/O Description of Device Functions - FMC ...
Proline Promass 83E/F/O Description of Device Functions - FMC ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Esc<br />
4 Block QUICK SETUP <strong>Device</strong> <strong>Functions</strong> <strong>Proline</strong> <strong>Promass</strong> 83<br />
4.5 Data back-up/transfer<br />
You can use the T-DAT SAVE/LOAD function to transfer data (device parameters and settings)<br />
between the T-DAT (removable memory) and the EEPROM (device memory).<br />
This is required for the following applications:<br />
• Creating a backup: current data are transmitted from an EEPROM to the T-DAT.<br />
• Replacing a transmitter: current data are copied from an EEPROM to the T-DAT, then transmitted<br />
to the EEPROM <strong>of</strong> the new transmitter.<br />
• Duplicating data: current data are copied from an EEPROM to the T-DAT, then transmitted to<br />
EEPROMs <strong>of</strong> identical measuring points.<br />
! Note!<br />
Installing and removing the T-DAT Operating Instructions <strong>of</strong> the <strong>Promass</strong> 83 (BA059D)<br />
XXX.XXX.XX<br />
-<br />
+<br />
E<br />
F<br />
O<br />
Quick Setup<br />
HOME<br />
POSITION<br />
N<br />
T-DAT<br />
SAVE/LOAD<br />
LOAD<br />
F<br />
P<br />
SAVE<br />
F<br />
P<br />
CANCEL<br />
YES<br />
F<br />
P<br />
Restart <strong>of</strong> the<br />
measuring device<br />
NO<br />
F<br />
YES<br />
F<br />
Input is<br />
saved<br />
P<br />
NO<br />
F<br />
Data storage/transmission with T-DAT SAVE/LOAD<br />
a0001221-en<br />
Notes on the LOAD and SAVE options:<br />
LOAD:<br />
Data are transmitted from the T-DAT to the EEPROM.<br />
! Note!<br />
• Previously saved settings on the EEPROM are deleted.<br />
• This selection is available only if the T-DAT contains valid data.<br />
• This selection can be made only if the s<strong>of</strong>tware version <strong>of</strong> the T-DAT is the same or newer than<br />
that <strong>of</strong> the EEPROM. Otherwise, the error message "TRANSM. SW-DAT" appears after the restart<br />
and the LOAD function is subsequently no longer available.<br />
SAVE:<br />
Data are transmitted from the EEPROM to the T-DAT.<br />
Page 34 • MN0M023<br />
Issue/Rev. 0.2 (12/12)