Proline Promass 83E/F/O Description of Device Functions - FMC ...
Proline Promass 83E/F/O Description of Device Functions - FMC ...
Proline Promass 83E/F/O Description of Device Functions - FMC ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Esc<br />
<strong>Device</strong> <strong>Functions</strong> <strong>Proline</strong> <strong>Promass</strong> 83<br />
4 Block QUICK SETUP<br />
4.2 Pulsating flow Setup menu<br />
XXX.XXX.XX<br />
-<br />
+ E<br />
E<br />
++<br />
Quick Setup<br />
B<br />
HOME-POSITION<br />
+E<br />
QS 1003<br />
Plusating Flow<br />
Display<br />
damping<br />
2002<br />
m Selection totalizer<br />
Totalizer 1 Totalizer 2<br />
Totalizer 3<br />
Quit<br />
Totalizer 3002 Totalizer 3002 Totalizer 3002<br />
mode (DAA)<br />
mode (DAB)<br />
mode (DAC)<br />
Yes<br />
n Configure another totalizer <br />
No<br />
oSelection <strong>of</strong> output type<br />
Current output n<br />
Freq.-/Puse output n<br />
Quit<br />
4200<br />
Operation mode<br />
Frequency<br />
Pulse<br />
4004<br />
Measuring mode<br />
4005<br />
Time constant<br />
4206<br />
Measuring mode<br />
4208<br />
Time constant<br />
4225<br />
Measuring mode<br />
Yes<br />
p Configure another output <br />
No<br />
8005<br />
Alarm delay<br />
Assign<br />
LF-Cut <strong>of</strong>f<br />
On-value<br />
LF-Cut <strong>of</strong>f<br />
Off-value<br />
LF-Cut <strong>of</strong>f<br />
6400<br />
6402<br />
6403<br />
Pressure 6404<br />
shock suppression<br />
Quit<br />
Quick Setup<br />
A0002615-en<br />
m<br />
n<br />
o<br />
p<br />
Only totalizers not yet configured in the current Setup are <strong>of</strong>fered for selection in each cycle.<br />
The “YES” option remains visible until all the totalizers have been configured. “NO” is the only option displayed<br />
when no further totalizers are available.<br />
Only the outputs not yet configured in the current Quick Setup are <strong>of</strong>fered for selection in each cycle.<br />
The “YES” option remains visible until all the outputs have been configured. “NO” is the only option displayed<br />
when no further outputs are available.<br />
Issue/Rev. 0.2 (12/12) MN0M023 • Page 29
Change language