Proline Promass 83E/F/O Description of Device Functions - FMC ...

More documents

Recommendations

Info

4 Block QUICK SETUP Device Functions Proline Promass 83 Function description QUICK SETUP QUICK SETUP BATCHING/DOSING (1005) ! Note! This function is only available when the optional software package BATCHING is installed. Use this function to start the (optional) application specific Setup menu for batching. Options: YES NO Factory setting: NO ! Note! You will find a flowchart of the BATCHING setup menu on page 32. For more information on Setup menus, please refer to the Operating Instructions Proline Promass 83, BA 059D/06/en. T-DAT SAVE/LOAD (1009) Use this function to save the parameter settings / configuration of the transmitter in a transmitter DAT (T-DAT), or to load the parameter settings from the T-DAT into the EEPROM (manual safety function). Application examples: • After commissioning, the current measuring point parameters can be saved to the T-DAT as a backup. • If the transmitter is replaced for some reason, the data from the T-DAT can be loaded into the new transmitter (EEPROM). Options: CANCEL SAVE (from EEPROM to T-DAT) LOAD (from the T-DAT into EEPROM) Factory setting: CANCEL ! Note! • If the target device has an older software version, the message “TRANSM. SW–DAT” is displayed during startup. Then only the “SAVE” function is available. • LOAD This function is only possible if the target device has the same software version as, or a more recent software version than, the source device. •SAVE This function is always available. Page 26 • MN0M023 Issue/Rev. 0.2 (12/12)
Esc Device Functions Proline Promass 83 4 Block QUICK SETUP 4.1 Setup Commissioning XXX.XXX.XX - + E HOME-POSITION B E ++ Quick Setup +E QS 1002 Commission 2000 Language Pre-setting m Selection pre-settings Delivery Settings Actual Settings n Selection system units Mass flow Volume flow Corr. Vol. flow Density Temperature Quit Unit 0400 Mass flow Unit 0402 Volume flow Unit 0404 Corr. Vol. flow Unit 0420 Density Unit 0422 Temperature Unit 3001 Totalizer Unit 3001 Totalizer Corr. Vol. 6460 calculation Reference Density Calculated Unit 0421 6462 Ref. Density Exp. Coeff. Lin 6461 6463 Fix. Density Exp. Coeff. SQR 6464 Reference temp. Yes o Configure another system unit No p Selection output type Current output n Freq./Pulse output n Quit 4200 Operation Mode Assign 4000 Current output 4001 Current span 4002 Value 0/4 mA 4003 Value 20 mA 4004 Meas. mode 4005 Time constant 4006 Failsafe mode Frequency Assign 4201 Freq. output 4203 End value freq. 4204 Value F Low 4205 Value F High 4206 Meas. mode 4207 Output signal 4208 Time constant 4209 Failsafe mode Pulse Assign 4221 Pulse output 4222 Pulse value 4223 Pulse width 4225 Meas. mode 4226 Output signal 4227 Failsafe mode Yes q Configure another output No Yes r Automatic configuration of display No Automatic parameterization of the display Carrying out another Quick Setup s Batching Pulsating flow Gas measurement No Carrying out the selected Quick Setup A0004561-en Issue/Rev. 0.2 (12/12) MN0M023 • Page 27
Page 1 and 2: Issue/Rev. 0.2 (12/12) Coriolis Mas
Page 3 and 4: Device Functions Proline Promass 83
Page 25: Device Functions Proline Promass 83
Page 29 and 30: Esc Device Functions Proline Promas
Page 77 and 78:
Device Functions Proline Promass 83
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
show all

Proline Promass 83E/F/O Description of Device Functions - FMC ...

Create successful ePaper yourself

Delete template?

Save as template?