6. operating the zmv-p - Grass

5. SHIPPING - START-UP
5.3 Assembling the Machine
5.3.1 The machine is shipped unassembled.
1. Lay the frame gibs out correctly (back strip with the hose, the air socket directed towards the rear) on a suitable
table or stand.
2. Slide the rigid sled up, clamping flush left
Necessary tool:
Necessary accessory:
hexagon socket screw key SW 4 mm
hexagon socket screw key SW 5 mm
premounted
3. Slide the movable sled up - no clamping required.
4. Fasten lateral gibs
Necessary tool:
Necessary accessory
hexagon socket screw key SW 5 mm
hexagon socket screw M6
diameter 5 dowel pin
5. Attach the ends of the hose to the air inlet socket.
5.4 Installation at the Final Destination Site
5.4.1 Fastening to the worktable with the angle bracket, which is included in the shipment
5.4.2 Fix the foot pedal to the appropriate position on the floor
5.5 Setting the ZMV-p
No setting is necessary because the frame and profile are preset.
5.6 Start-Up
5.6.1 Pneumatic connection
The ZMV-p is provided with a 2 meter long air hose with a diameter of 6/3“. A Euro-Quick coupling is mounted
according to the system in the destination country.
• Lift the setting button of the maintenance unit up and turn it counterclockwise.
• Connect the pneumatic compressed air with a quick coupling or a stop valve with ventilation.
• Caution: The machine operator must always be able to disconnect the machine from the compressed air system
within a maximum distance of 3 meters.
• Lift the setting button of the maintenance unit up and turn clockwise. The manometer (pressure gauge) reads
5.5 - 6 bar ( 0.55 - 0.6 Mpa). Press the adjusting button down.
The star in your cabinet
15