FBs-4DA/2DA 4 or 2 Channels Analog Output ... - SEA spol. s ro

More documents

Recommendations

Info

<strong>FBs</strong>-<strong>4DA</strong>/<strong>2DA</strong> 4 <strong>or</strong> 2 <strong>Channels</strong> <strong>Analog</strong> <strong>Output</strong> Module Wiring Diagram 2/2
<strong>FBs</strong>-<strong>4DA</strong>/<strong>2DA</strong> 4 <strong>or</strong> 2 <strong>Channels</strong> <strong>Analog</strong> <strong>Output</strong> Module Jumper Setup <strong>Output</strong> Code F<strong>or</strong>mat Selection There are two f<strong>or</strong>mats of output code can be selected, one is Unipolar and the other is Bipolar. The range of the Unipolar code value is 0~16383 while the Bipolar is –8192~8191. The extreme two ends of the code value c<strong>or</strong>responding to the minimal and maximal analog output level respectively. F<strong>or</strong> example, if the analog signal is set to –10V~+10V range, f<strong>or</strong> the same code value 0, the Bipolar code will result 0V output, while the Unipolar code will result –10V output, f<strong>or</strong> the code value 8191, the Bipolar code will result 10V output, while the Unipolar code will result 0V output. Code F<strong>or</strong>mat Range JP1 Setting Bipolar -8192 ~ +8191 Unipolar 0 ~ 16383 <strong>Output</strong> Signal Type Selection The output signal type of each channel can be set individually. There are two jumpers f<strong>or</strong> each channel to control the output signal type. The c<strong>or</strong>responding jumpers f<strong>or</strong> each channel are shown at below: CH0 CH1 CH0 CH1 JPA JPB CH2 CH3 CH2 CH3 JP1 3/3
Page 1: FBs-4DA</s

FBs-4DA/2DA 4 or 2 Channels Analog Output ... - SEA spol. s ro

Create successful ePaper yourself

Delete template?

Save as template?