Safety Manual for the Robomow RM 200 (PDF - Connox

More documents

Recommendations

Info

12. Over-heat Monitoring Protection The blade motor and each of the two wheel drive motors are monitored continuously during operation for any situation that may cause these motors to over-heat. In such event, Robomow will stop operation of at least that motor and possibly the mower itself and indicate that the motor is cooling down. While unusual, this may happen when the mower is on grass that is severely overgrown; the underside of the mower is clogged from poor cleaning maintenance; the mower has encountered an obstacle that is unable to activate the bumper sensor preventing it from moving; or a problem landscape area has caused the mower to get stuck and is preventing it from moving. WARNING! This warning symbol will be found at several points throughout the pages of this manual. It is intended to highlight an important safety, warning or cautionary message. Please pay particular attention to these areas and be sure you fully understand the message before proceeding. How It Works A small wire, called the perimeter wire, is placed around the perimeter of the lawn and any other areas where you do not want the mower to enter. A small signal is generated from a device attached to the perimeter wire, called the Perimeter Switch. When turned on, this signal is carried through the perimeter wire, creating what we define as a virtual wall. The virtual wall is visible only to Robomow, keeping Robomow where you want it, on your lawn. The perimeter switch must be turned on to activate the perimeter wire before Robomow will operate. Virtual wall 8 Perimeter Switch
What’s in the Box Open the box and lift the Robomow from its carrying handle. 9 Wire Plot Connector Power Supply Robomow ® RoboRuler Perimeter Switch Charging adaptor Pegs Wire Connector
Page 1 and 2: Operating & Safety Manual RM200 www
Page 3 and 4: 3 Table of Contents Safety Warnings
Page 5 and 6: Transport To safely move from or wi
Page 7: Robomow ® Safety Features 1. Child
Page 11 and 12: 11 1.2.2 Placing The Perimeter Swit
Page 13 and 14: While the picture shows two wires s
Page 15 and 16: 1.3.2 Laying Out The Perimeter Wire
Page 17 and 18: � Press the ‘ON’ button. A sm
Page 19 and 20: 19 Press ‘GO’ ‘ GO’ to test
Page 21 and 22: 2.1 Zones setup The ‘Zones setup
Page 23 and 24: 23 2.3 Information The ‘Informati
Page 25 and 26: Chapter 3 - Operation and Charging
Page 27 and 28: Chapter 4 - Text Messages and Troub
Page 29 and 30: 29 Message Displayed Low temperatur
Page 31 and 32: 31 4.2 Other Operational or Fault P
Page 33 and 34: WARNING! Chapter 5 - Maintenance an
Page 35 and 36: 5.5 Splicing the Perimeter Wire If
Page 37 and 38: 37 Chapter 7 - Accessories Blade Ke
Page 39 and 40: Friendly Robotics RM Series Limited

Safety Manual for the Robomow RM 200 (PDF - Connox

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?