Safety Manual for the Robomow RM 200 (PDF - Connox
Safety Manual for the Robomow RM 200 (PDF - Connox
Safety Manual for the Robomow RM 200 (PDF - Connox
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
31<br />
4.2 O<strong>the</strong>r Operational or Fault Problems<br />
Problem<br />
Encountered<br />
'Cut wire’ indicator<br />
flashing on<br />
Perimeter Switch<br />
or<br />
<strong>the</strong> Base Station<br />
beeps continuously<br />
<strong>for</strong> 'Cut wire’<br />
‘Poor connection’<br />
indicator flashing on<br />
Perimeter Switch<br />
or<br />
<strong>the</strong> Base Station<br />
beeps intermittently<br />
<strong>for</strong> poor wire<br />
splicing or too long<br />
wire<br />
<strong>Robomow</strong> doesn’t<br />
complete <strong>the</strong> edge<br />
<strong>Robomow</strong> will not<br />
operate and nothing<br />
will display on <strong>the</strong><br />
LCD screen.<br />
The <strong>Robomow</strong> is<br />
noisy and vibrates<br />
Poor quality of<br />
mowing (grass<br />
clippings are left on<br />
<strong>the</strong> lawn)<br />
or<br />
Uneven mowing<br />
results<br />
Probable Cause/Event Corrective/User Action<br />
- Wire disconnected from perimeter<br />
switch or from <strong>the</strong> Base Station.<br />
- Perimeter wire cut<br />
- Poor connections<br />
- Twisted cables, or a screw terminal,<br />
insulated with insulation tape is not a<br />
satisfactory splice. Soil moisture<br />
causes <strong>the</strong> conductors to oxidize and<br />
after a while result in broken circuit.<br />
- Perimeter wire too long <strong>for</strong> one zone<br />
- Confirm wire is plugged in and wire leads<br />
are firmly attached.<br />
- Walk along perimeter, including islands and<br />
look <strong>for</strong> obvious cuts or breaks in <strong>the</strong> wire.<br />
Repair with <strong>Robomow</strong> wire splice<br />
connectors.<br />
- Check and repair all loose/poor or corroded<br />
connections.<br />
- Use <strong>the</strong> connectors supplied in <strong>the</strong> box. It is<br />
waterproof and gives a reliable electrical<br />
connection.<br />
- A maximum perimeter wire length of 500 m<br />
is recommended. Areas requiring longer<br />
lengths should be broken into separate<br />
zones.<br />
- Peculiar geometry of <strong>the</strong> perimeter - Per<strong>for</strong>m ‘Learn edge (refer to 2.1.2.2)<br />
- Mower is in deep sleep.<br />
- Batteries have been discharged from<br />
lack of charge maintenance.<br />
- Damaged or unbalanced blade<br />
- Grass is too high in relation to <strong>the</strong> set<br />
cutting height<br />
- Grass is wet<br />
- If not connected to <strong>the</strong> Base Station/charger<br />
at all times when not in use, <strong>the</strong> <strong>Robomow</strong><br />
will conserve power by entering into a deep<br />
sleep mode. Press <strong>the</strong> main switch button<br />
(on/off) 3 seconds continuously to wake<br />
<strong>Robomow</strong> or remove <strong>the</strong> fuse <strong>for</strong> 3<br />
seconds.<br />
- It is required <strong>for</strong> <strong>the</strong> charger to remain<br />
connected to <strong>Robomow</strong> when not in use.<br />
Failure to do so can cause permanent<br />
damage to <strong>the</strong> batteries. Contact your<br />
service provider.<br />
- Check <strong>the</strong> lawn is free from branches,<br />
stones or o<strong>the</strong>r objects that can damage <strong>the</strong><br />
blade be<strong>for</strong>e operating <strong>the</strong> <strong>Robomow</strong>.<br />
- Replace <strong>the</strong> blade<br />
- Dull blade - Replace blade.<br />
- <strong>Robomow</strong> works too few operations<br />
per week<br />
- It is recommended to cut not more than a<br />
1/3 of <strong>the</strong> green part of <strong>the</strong> grass.<br />
- Set <strong>the</strong> cutting height to a higher position<br />
- Use <strong>Robomow</strong> more frequently to maintain<br />
your lawn.<br />
- For best cut, operate <strong>Robomow</strong> when <strong>the</strong><br />
grass is dry. It is recommended to mow<br />
grass early afternoon.<br />
- Update <strong>the</strong> weekly program <strong>for</strong> more<br />
operations per week.<br />
- Working area is too large - Limit <strong>the</strong> working area