User Guide Product(range) - Neopost

More documents

Recommendations

Info

3. Enter/ change the default settings • Set the values for Port Number, IP Address, Subnet Mask and Gateway IP Address according to your needs or leave the default values. Port Number: 9100 IP Address: 192.168.50.180 Subnet Mask: 255.255.255.0 Gateway IP Address: 192.168.50.180 • Confirm any changes to the values by pressing the Ok key. Now press the Cancel key until the main view is shown in the display. • Press the Ok key to turn the printer online. The bottom line of the display must now show: OnlinTCP Changing the PC’s IP address Please note all your network settings before performing the configuration described below. When you want to use this PC in your LAN again, the network settings of this PC have to be reconfigured. 4. Configure the network settings of the PC In order to use this connection you have to set a fixed IP address for this PC. • Open the “Network and Sharing Center” on your PC (START > Control Panel > Network and Internet). • Click onto “Change adapter settings”. • Select the „Local Area Connection” and click onto “Change Settings of this connection”. • Deactivate the item “Internet Protocol Version 6 (TCP/IPv6)” and then select the “Internet Protocol Version 4 (TCP/IPv4)” and click onto “Properties” (see Figure 50) • Select “Use the following IP address:” and enter the following values (see Figure 51): IP address: The first three parts of the address must be the same as in the printer. The last part must be different! Subnet mask: Same as in the printer. Default gateway: Must be the same as the IP address in the printer. • Click onto “OK” and wait until the connection to the printer is established. 90 <strong>User</strong> Manual Version 3.1
Pos: 62 /Bedienungsanleitungen/Geräte neutral/8.0_Ü1_Service @ 0\mod_1251192378636_912.doc @ 3024 @ 31 Figure 50: Local Area Connection Properties Figure 51: TCP/IPv4 settings 5. Install and configure the printer driver • Install and configure the printer driver for your printer model as described in chapter 7.1 on page 79. <strong>User</strong> Manual Version 3.1 91
Page 1 and 2:
as-930 aDDress PrInTer User ManUal
Page 3 and 4:
Pos: 3 /[Allgemeines]/0.0a_Note_Tra
Page 5 and 6:
6 Printer menu (firmware V4.8).....
Page 7 and 8:
Table of Figures Figure 1:AS-930 Ov
Page 9 and 10:
Pos: 8 /Bedienungsanleitungen/Gerä
Page 11 and 12:
Pos: 13 /Bedienungsanleitungen/Ger
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
2: Ink costs and ink range This lin
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
fixing screws lift those separation
Page 31 and 32:
Page 33 and 34:
wing screw print area Figure 14: Po
Page 35 and 36:
Page 37 and 38:
Page 39 and 40: JOB PARAMETERS.....................
Page 41 and 42: Pos: 60.3 /Bedienungsanleitungen/Ge
Page 45 and 46: MAIN MENU The Home key opens the ma
Page 47 and 48: KEEP ALIVE Here you can turn on the
Page 49 and 50: Pos: 60.23 /Bedienungsanleitungen/G
Page 67 and 68: LED/Beeper Here you can check if al
Page 71 and 72: Pos: 60.109 /Bedienungsanleitungen/
Page 81 and 82: 2. Connect the PC to the printer
Page 85 and 86: Correct IP address syntax Don’t e
Page 87 and 88: 7.4.3 Using a fixed IP address 1. P
Page 89: Pos: 61.7 /Bedienungsanleitungen/Ge
Page 93 and 94: Pos: 66 /Bedienungsanleitungen/Ger
Page 125 and 126: Pos: 85 /Serviceanleitungen/Geräte
Page 127 and 128: Pos: 90 /Zubehör/Generelles Zubeh
Page 137 and 138: 11.4 How to test the Ethernet conne
Page 139 and 140: 11.5 Network connection between the
Page 141 and 142:
Page 143 and 144:
11.7 How to create a print file Dep
Page 145 and 146:
Pos: 100 /Serviceanleitungen/Gerät
Page 147 and 148:
4 • Enable “Send to printer”
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
12 Glossary Term Addressing ASCll B
Page 155 and 156:
Font inclination Font type HP TIJ 2
Page 157 and 158:
Printer Driver Printhead Printhead
Page 159 and 160:
13 Index Accessories ..............
Page 161:
9204019U-B edition 08/04/2011 - 920
show all

User Guide Product(range) - Neopost

Create successful ePaper yourself

Delete template?

Save as template?