User Guide Product(range) - Neopost

7.4.3 Using a fixed IP address
1. Printer
settings “fix
IP”
• Open the main menu of the printer with the Home key.
• Open the menu PRINTER CONFIG. > BOOT DEFAULTS >
COMMUNICATION > TCP/IP.
• In this menu select the setting fix IP.
In the next menu you can set the values for Port Number, IP
Address, Subnet Mask and Gateway IP Address.
Port number
IP Address
Subnet Mask
Gateway IP Address
The default port 9100 is commonly used by printers. Please make
sure that this port is not blocked in your LAN or use a port number
that is accessible in your LAN.
Please enter an IP address that is valid with your LAN.
Please enter the Subnet Mask of your LAN.
Please enter the IP address of the server of your LAN.
2. Enter/
change the
default
settings
• The printer default values are shown below.
Port Number: 9100
IP Address: 192.168.50.180
Subnet Mask: 255.255.255.0
Gateway IP Address: 192.168.50.180
• Confirm any changes to the values by pressing the Ok key. Now
press the Cancel key until the main view is shown in the display.
• Press the Ok key to turn the printer online. The bottom line of
the display must now show: OnlinTCP
7.4.3.1 Using a dynamic IP address
1. Printer
settings
“dynamic IP”
• Open the main menu of the printer with the Home key.
• Open the menu PRINTER CONFIG. > BOOT DEFAULTS >
COMMUNICATION > TCP/IP.
• In this menu select the setting dynamic IP.
• In the next menu you can set the value for the Port Number.
Port number
The default port 9100 is commonly used by printers. Please make
sure that this port is not blocked in your LAN or set to a port
number that is used in your LAN.
User Manual Version 3.1 87