User Guide Product(range) - Neopost

More documents

Recommendations

Info

3. Install the driver with the New Hardware Wizard • Follow the steps of the New Hardware Wizard of Windows XP/Vista • If asked select the installation choices as shown in Figure 35 and Figure 36. The Wizard will search the content of the CD-ROM for the drivers and will install them. Figure 35: New Hardware Wizard Figure 36: Recommended install procedure • After the installation the printer is ready to use. During the installation, the Wizard might prompt that the driver is not approved by Windows. Please continue the installation by clicking on “Continue Anyway” 7.2.1 Windows 7 1. Insert the driver CD-ROM • Insert the Neopost CD-ROM in the CD drive of your PC. 80 User Manual Version 3.1
2. Connect the PC to the printer • Make sure that your printer is turned off. • Connect the printer with the USB cable to your PC. • Turn on the printer. Check if the printer shows OnlinUSB in the bottom line of the main display. If not press the Ok key to turn the printer online. If the printer shows OnlinTCP in the bottom line of the main display use the menu PRINTER CONFIG. > BOOT DEFAULTS > COMMUNICATION to select the USB interface. • Wait for the automatic detection of the new hardware. • By clicking on the message box, Windows will display a status window. • Windows 7 is not able to locate the printer drivers on the CD-ROM or in the Internet automatically. Therefore you have to install the printer driver manually. 3. Install the driver manually • Click on the Windows button and “Devices and Printers” • The detected printer is listed under the category “Unspecified”. Right-click on it and select “Properties”. • Go to the tab “Hardware” and see the listed device functions (see Figure 37). Double-click on the printer (Type: Other devices); another properties window will open. • Select the button “Change Settings” (administrator rights required). The window will flicker once. • Switch to the tab “Driver” and select the button “Update driver” (see Figure 38). The “Update Driver Software” Wizard will appear. User Manual Version 3.1 81
Page 1 and 2:
as-930 aDDress PrInTer User ManUal
Page 3 and 4:
Pos: 3 /[Allgemeines]/0.0a_Note_Tra
Page 5 and 6:
6 Printer menu (firmware V4.8).....
Page 7 and 8:
Table of Figures Figure 1:AS-930 Ov
Page 9 and 10:
Pos: 8 /Bedienungsanleitungen/Gerä
Page 11 and 12:
Pos: 13 /Bedienungsanleitungen/Ger
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
2: Ink costs and ink range This lin
Page 25 and 26:
Page 27 and 28:
Page 29 and 30: fixing screws lift those separation
Page 31 and 32: Pos: 51 /Bedienungsanleitungen/Ger
Page 33 and 34: wing screw print area Figure 14: Po
Page 39 and 40: JOB PARAMETERS.....................
Page 41 and 42: Pos: 60.3 /Bedienungsanleitungen/Ge
Page 45 and 46: MAIN MENU The Home key opens the ma
Page 47 and 48: KEEP ALIVE Here you can turn on the
Page 49 and 50: Pos: 60.23 /Bedienungsanleitungen/G
Page 67 and 68: LED/Beeper Here you can check if al
Page 71 and 72: Pos: 60.109 /Bedienungsanleitungen/
Page 79: Pos: 61.2 /Bedienungsanleitungen/Ge
Page 85 and 86: Correct IP address syntax Don’t e
Page 87 and 88: 7.4.3 Using a fixed IP address 1. P
Page 125 and 126: Pos: 85 /Serviceanleitungen/Geräte
Page 127 and 128: Pos: 90 /Zubehör/Generelles Zubeh
Page 131 and 132:
Pos: 96.1 /Bedienungsanleitungen/Ge
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
11.4 How to test the Ethernet conne
Page 139 and 140:
11.5 Network connection between the
Page 141 and 142:
Page 143 and 144:
11.7 How to create a print file Dep
Page 145 and 146:
Pos: 100 /Serviceanleitungen/Gerät
Page 147 and 148:
4 • Enable “Send to printer”
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
12 Glossary Term Addressing ASCll B
Page 155 and 156:
Font inclination Font type HP TIJ 2
Page 157 and 158:
Printer Driver Printhead Printhead
Page 159 and 160:
13 Index Accessories ..............
Page 161:
9204019U-B edition 08/04/2011 - 920
show all

User Guide Product(range) - Neopost

Create successful ePaper yourself

Delete template?

Save as template?