User Guide Product(range) - Neopost
User Guide Product(range) - Neopost
User Guide Product(range) - Neopost
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Pos: 61.2 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Printer Driver & Cables to PC/7.X_Ü2_How to install and configure the printer driver_ONLY_619 @ 3\mod_1295280186142_912.doc @ 29403 @ 2233<br />
7 How to connect the printer to the PC<br />
To connect the printer to a PC, use either the USB interface or the Ethernet interface of the<br />
printer. To connect the printer to a network, use the Ethernet interface.<br />
Independent from the interface (USB or Ethernet), it is necessary to install a printer driver<br />
on the PC that will be used to send data to the printer.<br />
Follow the installation procedures<br />
Please follow the installation procedures described in this chapter.<br />
Please stick to the order of installation steps (e.g connecting the<br />
printer to the PC) as described in this chapter.<br />
• Please see chapter 7.1 on how to install and configure the printer driver.<br />
• Please see chapter 7.3 on how to use the USB interface<br />
• Please see chapter 7.4 on how to use the Ethernet interface<br />
The printer will work either with the USB interface or with the<br />
Ethernet interface. The two interfaces cannot be used together at the<br />
same time.<br />
7.1 How to install the printer driver<br />
7.2 Windows XP and Windows Vista<br />
1. Insert the<br />
driver CD-ROM<br />
• Insert the <strong>Neopost</strong> CD-ROM in the CD drive of your PC.<br />
2. Connect the<br />
PC to the<br />
printer<br />
• Make sure that your printer is turned off.<br />
• Connect the printer with the USB cable to your PC.<br />
• Turn on the printer. Check if the printer shows OnlinUSB in the<br />
bottom line of the main display.<br />
If not press the Ok key to turn the printer online.<br />
If the printer shows OnlinTCP in the bottom line of the main<br />
display use the menu PRINTER CONFIG. > BOOT DEFAULTS ><br />
COMMUNICATION to select the USB interface.<br />
• Wait for the automatic detection of the new hardware.<br />
• Proceed with the installation of the printer driver.<br />
<strong>User</strong> Manual Version 3.1 79