User Guide Product(range) - Neopost
User Guide Product(range) - Neopost
User Guide Product(range) - Neopost
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Pos: 60.86 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_3235_Prewarming @ 1\mod_1255684370577_912.doc @ 6659 @<br />
Pos: 60.87 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_3236_PEN Board @ 1\mod_1255684373658_912.doc @ 6663 @<br />
Pos: 60.88 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_3241_LED/ Beeper @ 0\mod_1254916802136_912.doc @ 5103 @<br />
Cartridges<br />
This test checks the electronically connections between cartridge mountings and printheads.<br />
The results of the test are shown in the display.<br />
Test<br />
HP PEN ID<br />
MISSING DOTS<br />
Note<br />
The identification code of each PEN board (e. g 13 =<br />
Unit U1, Cartridge C3).<br />
Number of missing dots of the cartridges, that can’t<br />
be controlled by the printer.<br />
If all nozzles response correctly, the display will show<br />
“no”.<br />
Amount of missing dots<br />
The amount of missing dots (MISSING DOTS) can be an evidence, that<br />
the connection between printhead and cartridge mounting is<br />
interfered.<br />
If the amount of missing dots is a multiple of seven (14, 21, 28, ...),<br />
the problem lies most likely in a draggled printhead contacting.<br />
In this case, clean the contacts of the printhead and that of the<br />
cartridge mounting with a piece of cloth, an repeat the test.<br />
Prewarming<br />
The Prewarming function of the printer will be checked in this test. Afterwards the printer<br />
should display the “PREWARMING:o Data/s” status.<br />
PEN Board<br />
This test will check the circuit (PEN) boards that are integrated in the print units. The test<br />
will be performed with all circuit boards of the printer.<br />
Authorised service personal can use the values of this test for service purposes.<br />
Test<br />
AMB.TEMP<br />
REF.RES[h]<br />
TSR [Hex]<br />
Note<br />
The measured temperature close to the printhead<br />
nozzles in degree Celsius °C<br />
“Reference Resistor” – reference value<br />
„Thermal Sense Resistor“ - resistance value inside the<br />
printhead<br />
66 <strong>User</strong> Manual Version 3.1
Change language