User Guide Product(range) - Neopost
User Guide Product(range) - Neopost
User Guide Product(range) - Neopost
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Pos: 60.65 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü2/Ü2_2700_DOS_MODE @ 0\mod_1254832327765_912.doc @ 4361 @<br />
Pos: 60.67 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_2702_HEX TO ASCII @ 0\mod_1254915739923_912.doc @ 5003 @<br />
Pos: 60.68 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_2703_AUTO LINEFEED @ 0\mod_1254915734173_912.doc @ 4975 @<br />
PAPER SENSOR<br />
Here you can adjust the behaviour of the paper sensor.<br />
Option<br />
On<br />
Off<br />
Note<br />
The paper sensor (also Top of Form (TOF) sensor)<br />
detects the front edge and the rear edge of the<br />
material. In this setting the paper sensor is active<br />
over the complete length of the material. The paper<br />
length is controlled in this setting, so paper jams or<br />
double feeds will be detected.<br />
The paper sensor detects the front edge of the<br />
material. Then the paper sensor is set to inactive until<br />
5 mm before the anticipated rear edge of the<br />
material. This allows to process materials that have<br />
e.g. a colourful surface or a hole (die cut) in them.<br />
The paper length is controlled in this setting, so paper<br />
jams or double feeds will be detected.<br />
To properly use this setting, the<br />
correct material size must be<br />
set in the printer. Either sent by<br />
the PC software or measured<br />
manually.<br />
If the material separation and<br />
transport is not setup correctly,<br />
turning off the paper sensor can<br />
cause misprints.<br />
Default: On<br />
DOS MODE<br />
Pos: 60.66 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_2701_LINE MODE @ 0\mod_1254915736970_912.doc @ 4987 @<br />
LINE MODE<br />
This feature is used to set a number of lines that separate one page (address) from the<br />
next.<br />
0 to 36<br />
Default: 0<br />
HEX TO ASCII<br />
Conversion from HEX to ASCII.<br />
If the conversion is switched on, the printer interprets the percentage sign “%“ as a nonprintable<br />
control character. The two characters following the % sign are interpreted as HEX<br />
values, e.g. %0C = Form Feed.<br />
off, on<br />
Default: off<br />
62 <strong>User</strong> Manual Version 3.1
Change language