Eclipse ThermJet Burners - Power Equipment Company

More documents

Recommendations

Info

Troubleshooting Guide (Continued) PROBLEM POSSIBLE CAUSE SOLUTION The low fire flame is weak or unstable • Low fire adjusted too low • Not enough gas Increase low fire gas setting Check start-up settings and adjust to increase low gas flow The burner goes off when it cycles to high fire • Not enough air • Insufficient air (flame too rich) Check sart-up settings. Investigate any change, i.e. blocked filter, loose connections Check start-up settings Check air filter, clean or replace if required The burner is erratic and does not respond to adjustment The burner is unstable or produces soot or smoke Cannot achieve full capacity • Flame signal weak • Internal damage to the burner. Some parts inside the burner my be loose or dirty • The air/gas ratio is out of adjustment • Air filter is blocked • Gas pressure is too low into the main gas pressure regulator Check condition of flame monitoring device Contact your Eclipse representative or the Eclipse factory Measure all the gas pressures and air pressures. Compare to initial start-up settings, and adjust them where necessary Clean or replace the air filter Adjust gas pressure • Increased furnace/chamber pressures • Poor piping practices Re-check setup pressures Contact factory 32 Eclipse ThermJet v2, Installation Guide No. 205, 3/5/07
Appendix Conversion Factors Metric to English. FROM TO MULTIPLY BY cubic meter (m 3 ) cubic foot (ft 3 ) 35.31 cubic meter/hour (m 3 /h) cubic foot/hour (cfh) 35.31 degrees Celsius (°C) degrees Fahrenheit (°F) (°C x 1.8) + 32 kilogram (kg) pound (lb) 2.205 kilowatt (kW) Btu/hr 3414 meter (m) foot (ft) 3.28 millibar (mbar) inches water column (“wc) 0.401 millibar (mbar) pounds/sq in (psi) 14.5 x 10 -3 millimeter (mm) inch (in) 3.94 x 10 -2 Metric to Metric. FROM TO MULTIPLY BY kiloPascals (kPa) millibar (mbar) 10 meter (m) millimeter (mm) 1000 millibar (mbar) kiloPascals (kPa) 0.1 millimeter (mm) meter (m) 0.001 English to Metric. FROM TO MULTIPLY BY Btu/hr kilowatt (kW) 0.293 x 10 -3 cubic foot (ft 3 ) cubic meter (m 3 ) 2.832 x 10 -2 cubic foot/hour (cfh) cubic meter/hour (m 3 /h) 2.832 x 10 -2 degrees Fahrenheit (°F) degrees Celsius (°C) (°F – 32) ÷ 1.8 foot (ft) meter (m) 0.3048 inches (in) millimeter (mm) 25.4 inches water column (“wc) millibar (mbar) 2.49 pound (lb) kilogram (kg) 0.454 pounds/sq in (psi) millibar (mbar) 68.95 Eclipse ThermJet v2, Installation Guide No. 205, 3/5/07 33
Page 1 and 2: Installation Guide 205 3/5/07 Eclip
Page 3 and 4: About this manual Audience This man
Page 5 and 6: Table of contents 1 2 3 4 Introduct
Page 7 and 8: Introduction 1 Product Description
Page 9 and 10: Safety (Continued) Capabilities Ope
Page 11 and 12: Approval of Components (Continued)
Page 13 and 14: Prepare The Burner Several componen
Page 15 and 16: Burner Installation Dimensions The
Page 17 and 18: Valve Installation Valve orientatio
Page 19 and 20: Adjustment, Start & Stop 4 Introduc
Page 21 and 22: Step 3: Set low fire air 1. 2. 3. 4
Page 23 and 24: Step 8: Verify the gas settings Mak
Page 25 and 26: 4. 5. Set the adjusting screw on th
Page 27 and 28: Start procedure Stop Procedure 1. 2
Page 29 and 30: Yearly Checklist 1. 2. 3. 4. 5. 6.
Page 31: Troubleshooting Guide (Continued) P
Page 35 and 36: ThermJet Illustrated Parts Drawing
Page 37 and 38: ThermJet Illustrated Parts List (Re

Eclipse ThermJet Burners - Power Equipment Company

Create successful ePaper yourself

Delete template?

Save as template?