Eclipse ThermJet Burners - Power Equipment Company

Installation
3
Introduction
Handling and
Storage
In this section you will find the information and instructions
needed to install the burner and system components.
Handling
1. Make sure the area is clean.
2. Protect the components from weather, damage, dirt and moisture.
3. Protect the components from excessive temperatures and humidity.
Storage
1. Make sure the components are clean and free of damage.
2. Store the components in a cool, clean, dry room.
3. After making sure everything is present and in good condition,
keep the components in original packages as long as possible.
Position of
Components
Approval of
Components
The position and amount of components are determined by the
kind of control method chosen. All the control methods can be
found in Design Guide 205, Chapter 3 “System Design.” Use
the schematics in that chapter to build your system.
Limit controls and safety equipment
All limit controls and safety equipment must comply with the
current following standards:
•
•
•
•
•
•
•
NFPA Standard 86
NFPA Standard 86C
UL
FM
CGA
EN 746-2
All applicable local codes and/or standards
10 Eclipse ThermJet v2, Installation Guide No. 205, 3/5/07