Robinair 75650 Coolant Recycler - NY Tech Supply

Maintenance
Instructions
There are just a few routine maintenance
procedures required to keep your unit
operating properly.
CLEANING THE UNIT
1. After servicing your vehicle, return
all hoses and power leads to the side
brackets. Replace any adapters or
accessories in the storage area. This
will help prevent damage to the
components.
2. Regularly wipe off the unit to remove
any spilled coolant, grease, dust, and
other foreign materials.
CLEANING THE STRAINER
The strainer is located in the back of the
unit under the handles. Check the bowl
before each use and clean if any amount
of debris is present.
IMPORTANT! If the strainer plugs, the
drain and fill operation will not function
properly and may cause engine overheating.
Follow these steps to clean the strainer:
1. Set the control panel switch to OFF
and disconnect the air supply.
2. Remove the plastic bowl.
WARNING!
Wear proper protective equipment including
gloves and safety goggles when
removing and cleaning the strainers.
3. Remove the screen and rinse both the
bowl and the screen. Be careful not to
damage the screen, bowl or gasket.
4. Place the gasket and the screen in
the bowl and screw the bowl back on
to the body.
5. Hand tighten the bowl to the body
(do not use pliers or wrenches).
24
75650 AF Pro Plus Coolant Recycler