Operator's Manual High Pressure Breathing Air Compressors

Operator’s Manual
5. MAINTENANCE SCHEDULE
5.1. MAINTENANCE INTERVALS
CAUTION
For filter cartridge change intervals refer to chapter
5 !
Interval Maintenance work Sec.
Daily before taking unit into
operation
Check oil level with dipstick
Operate unit to final pressure and check function of final pressure valve
before opening outlet valve
1/2 hour after start--up Manual check of valve function 9.
Weekly or as required Check automatic condensate drain; open manual condensate drain
taps
25 operating hours after first
time operation/maintenance
work
Tighten drive belt(s), check all accessible screws and nuts are tightly
fitted and if necessary tighten to the stipulated torque.
250 operating hours Check drive belt(s)
Service micronic intake filter
Check safety valves
Check all connections for leakage
1000 operating hours Dismantle valves, clean, check, and replace if necessary
Mineral oil change
Clean sintered metal filter element(s)
2000 operating hours Synthetic oil change
Replace valves
3000 operating hours or as required
Check pistons and piston rings 18.
Annually Mineral oil change, if run for less than 1000 operating hours
Check opening pressure of safety valves
Annually or as required Check cycle counter; replace oil and water separator if required 11./5.
Biannually Synthetic oil change, if run for less than 2000 operating hours 2.
2.
7.
10.
12.
12.
3.
7.
-- --
9.
2.
4./5.
2.
9.
2.
7.
31