ncr/doc/RealPOS/7455/Technical_Manuals/7455_Re... - Alsys Data

Chapter 3: Setup 3-25
Set Supervisor/User Password
The Supervisor Password controls access to the setup utility. The User
Password controls access to the system at boot. [Set] indicates that a
password is present. [Clear] indicatesthatapasswordisnotpresent.
To enter a password, follow these steps:
Note: The User Password cannot be set until after the Supervisor
Password is set.
1. Move the cursor to the Set Supervisor Password or Set User Password
option and press Enter.
2. Key-in the password and press Enter.
3. Confirm the password by keying it in again and pressing Enter. A
Setup Notice confirms the changes have been saved.
4. Press Enter to return to the Security Menu Options screen.
Note: Ifthepasswordsarenotknown,theCMOSmustbeclearedas
described in Clearing the Passwords.
Diskette Access
Access to the diskette can be limited to the supervisor or can also be
given to the user.
1. Move the cursor to Diskette Access and press Enter.
2. Select the desired setting from the drop-down menu.
User
Supervisor