ncr/doc/RealPOS/7455/Technical_Manuals/7455_Re... - Alsys Data

Chapter 5: BIOS Updating Procedures 5-3
3. Apply power to the terminal so the CD-ROM drive can be opened.
4. Insert the BIOS update CD.
NCR 7455 BIOS and BIOS Update Software
LPIN: A3D-0022
5. Boot the client terminal.
You should see a message during boot indicating that the CD-ROM
has been recognized similar to the one below:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
6. Follow the screen prompts on the client to update the BIOS. You
can select from two methods to run the update program.
• Automatic BIOS Update – Update process runs unattended
Note: You will see a prompt for terminal model and serial
number information if the program detects invalid information
in the current BIOS, or if you are replacing the Processor Board,
in which case there is no model/serial number information in
the BIOS.
Important: Model/Serial Number is mandatory for FitClient
operation.
• Interactive BIOS Update – Permits you to input/replace the
model/serial number information stored in the BIOS.
Note: Model/Serial number data currently stored in the BIOS
is displayed during power up.
7. You should see a green window, indicating a successful update.
8. Remove the CD.
9. Press any key to reboot.
10. Enter Setup when the terminal reboots and load the Setup Defaults
(Exit Menu).