ncr/doc/RealPOS/7455/Technical_Manuals/7455_Re... - Alsys Data

4-2 Chapter 4: Operating System Recovery
Updating Procedures
Note: If your 7455 contains an integrated CD-ROM located on the
back of the unit, skip to step three.
1. Connect the external CD-ROM (2336-K007) drive to the parallel
port on the terminal.
2. Connect the opposite end of the CD-ROM cable (end with the
power connector pigtail) to the CD-ROM drive parallel connector.
Note: The parallel port on the 7455 is the Customer Display port.
Therefore, if your terminal is configured with a Customer Display, you
must temporarily disconnect it in order to use the CD-ROM drive.
3. Apply power to the terminal so the CD-ROM drive can be opened.
4. Insert the CD that contains the operating system image.
7455 Model Software CD LPIN
7455-22xx
Windows NT Windows 98 Windows 2000 DOS
D370-0474-0100 D370-0473-0100 D370-0518-0100 D370-0471-0100
5. Boot the system.
If you are using the external CD-ROM, you should see a message
during boot indicating that the CD-ROM has been recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
6. Follow the DOS screen prompts. After each entry, you are asked to
confirm your input. You can use 1 or y for Yes, 2 or n for No.