Operation Manual - CPS Products
Operation Manual - CPS Products Operation Manual - CPS Products
When the meter operates in manual ranging mode, push this button to change range to the higher one and hold this button for more than 3 seconds to return to auto range mode. 4.3 REL Push the button to set relative measurement mode. “REL” symbol will appear on LCD, and the current reading will be stored as reference. In the Relative mode, the value shown on the LCD is always the difference between the stored reference value and the present reading. If the new reading is the same as the reference value, the display will be zero. 4.4 % Hz This button is used to select frequency or duty cycle measurement. 5. LCD DISPLAY 6
Low battery indication Auto range indication Relative measurement indication Hold data indication DC input indication AC input indication Diode test indication Continuity indication Polarity indication Capacitance measurement unit Ohm measurement unit Frequency measurement unit Current measurement unit Duty cycle measurement indication 6. “VΩHz” jack This is positive input terminal for volt, diode, resistance, frequency, duty cycle and capacitance measurement. Connection is made to it using the red test lead. 7. “COM” jack This is negative (ground) input terminal for all measurement modes except current. Connection is made to it using the black test lead. 7
- Page 1 and 2: AC450 OPEN-JAW DIGITAL ELECTRICAL T
- Page 3 and 4: SAFETY INFORMATION This open jaw di
- Page 5 and 6: • Read these operating instructio
- Page 7: PANEL DESCRIPTION 1. Transformer ja
- Page 11 and 12: BACK VIEW 9
- Page 13 and 14: AC CURRENT MEASUREMENT 1. Set the r
- Page 15 and 16: MEASURING FREQUENCY NOTE: The input
- Page 17 and 18: RANGE 4V 40V 400V 1000V RESOLUTION
- Page 19 and 20: RANGE AUDIBLE CONTINUITY AND DIODE
- Page 23: CPS PRODUCTS, INC. 1010 East 31st S
When the meter operates in manual ranging mode, push<br />
this button to change range to the higher one and hold this<br />
button for more than 3 seconds to return to auto range<br />
mode.<br />
4.3 REL<br />
Push the button to set relative measurement mode. “REL”<br />
symbol will appear on LCD, and the current reading will<br />
be stored as reference. In the Relative mode, the value<br />
shown on the LCD is always the difference between the<br />
stored reference value and the present reading. If the new<br />
reading is the same as the reference value, the display will<br />
be zero.<br />
4.4 % Hz<br />
This button is used to select frequency or duty cycle<br />
measurement.<br />
5. LCD DISPLAY<br />
6