SB-Motor - Orbit Motion Technologies

7 Technical Data
NOTE
There are only a few diagnosis messages of the MotorController
(MC-4 diagnosis messages with reaction A) which do not permit a
controlled stop of the motor. In these few cases, the holding brake
of the motor is required for the complete brake procedure (EMER-
GENCY STOP).
The times are valid for direct current, regular operating temperature
and rated voltage. Separation time is the time from switching on the
power to the point when the torque has faded to 10% of the rated
torque. Connection time is the time from switching off the power
until the rated torque is reached.
CAUTION!
Power loss in case of long cables!
The brake may be worn out or damaged!
� The data for rated power and rated voltage apply at the connection
box. Check the data at the connection box. A higher or separate
power supply of the brake may be necessary. A too high
voltage can also damage the brake!
SB 056 SB 070 SB 105 SB 145 SB 205 Unit
holding moment 0,8 1,5 5 15 50 [Nm] ([lb-in.])
connection time 80 80 80 80 80 [ms]
separation time 200 200 200 200 200 [ms]
mass 0,8 2 3 5 14 [kg]
moment of inertia 0,17 0,4 0,63 1,95 10 [kgcm 2 ]
([lb-in.-s 2 ])
rated power 0,4 0,6 1,1 1,9 1,7 [W]
rated voltage 24 +/-10% 24 +/-10% 24 +/-10% 24 +/-10% 24 +/-10% [V] DC
Table 7-7: Technical data of the holding brake of the SB Motor
page 58 SB-Motor PacDrive
Korrekturausdruck
MSB_OpMan_07_us.FM