SB-Motor - Orbit Motion Technologies

6 Maintenance
6.7 Commissioning
Unpacking and
checking the
devices
Installation
Devices electrically
attach
Examination of
the safety
functions
further commissioning
according
to the concrete
system
We recommend to take up with the first commissioning ELAU
personnel.
This should not only occur for guarantee reasons, but
� the equipment checked,
� which determines optimal configuration,
� the service personnel is instructed at the same time.
Procedure
After removing the packing you check please
the devices for soundness. Only intact devices
may be put into operation.
Check please additionally the supply for completeness.
Compare the data on the basis the identification
plates.
Install afterwards the devices considering of
the request to the setting up place, the enclosure
and the EMC rules
Attach they now the devices, beginning with
protective grounding. Make sure they that all
clamps are fixed tightened, which are used
necessary cable diameters the screen were
correctly executed and no interruptions and
short-circuits to be present.
- To motor thermojunction or PTC.
- Functions the brake, if available?
- Does the emergency stop chain function?
- Do the emergency stop limit switches function?
See operating instruction of the packaging
machine manufacturer and the MotorControllers.
Table 6-1: Procedure of the first commissioning
see
„Transportation,
Storage,
Unpacking”
see
„Maintenance”
see
„Techncal Data“
and „Maintenance“
page 28 SB-Motor PacDrive
Korrekturausdruck
MSB_OpMan_06_us.FM