User Guide - Neopost
User Guide - Neopost
User Guide - Neopost
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Pos: 52 /Bedienungsanleitungen/Geräte spezifisch/Drucker/AS-830/5.6_Ü2_How to position the print unit_AS-830_930 @ 2\mod_1268645846866_912.doc @ 13419 @ 23<br />
5.4 How to adjust the printer to the material thickness<br />
To ensure a sharp and clean print quality and a safe material transport, you have to adjust<br />
the distance from the print unit to the material.<br />
• Open the wing screw (see Figure 12).<br />
• Turn the thickness adjustment screw to the appropriate value.<br />
For material up to 0.3 mm thickness you can use the lowest position.<br />
• Tighten the wing screw again.<br />
thickness adjustment<br />
screw<br />
wing screw<br />
Figure 12: Adjusting the printer to the material thickness<br />
5.5 How to position the print area<br />
The vertical position of the print area must be setup manually.<br />
• Open the wing screw and move the unit to the desired position.<br />
• As a reference for the position of the print area, the two small rollers underneath the<br />
wing screw can be used. The print area is located between these two rollers (see<br />
indication in Figure 13).<br />
• Lock the wing screw again.<br />
30 <strong>User</strong> Manual Version 3.1
Change language