ZXP Series 7 User's Manual (en) - Hant

4: Printer Settings and Adjustments
Printing Preferences
• Printing options:
If you modify any of these settings, click the Apply button before printing a test card.
The Test Print button prints a test card.
• Ribbon info and options:
- Ribbon type shows the type of ribbon (e.g., YMCKOK) installed in the printer. Note
that this is automatically detected from the ribbon.
- Ribbon combination allows you to select the combination of panels to be printed
on each side (e.g., YMCKO Front/YMCKO Back).
- Depending on the ribbon type installed, the Front and Back buttons let you set
options for:
• Black Panel Options on page 79
• Overlay Varnish Options on page 82
• UV Panel Options on page 83
• Laminator info and options:
These options apply only to printers with laminator. This section automatically shows the
presence of the laminator and laminate. You can select the Lamination mode (Any, Top,
Bottom, Top and bottom, or Pass through) via the dropdown menu.
Pass through allows a card to pass through the laminator without having laminate applied.
Note that the laminate must be removed from the laminator for this option to work.
Laminate only can be used to laminate pre-printed cards. This is a special-purpose
function that is enabled when the Lamination mode is set to Top, Bottom, or Top and
bottom and the Card destination is set to Output hopper. When this option is selected, the
card is passed from the input hopper, through the printer without being printed, to the
laminator for lamination, then to the output hopper.
78 Zebra ZXP Series 7 Card Printer User’s Manual P1036101-001